lkml.org 
[lkml]   [2019]   [Dec]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/3] dmaengine: ti: k3-udma: Fixes against v6 series
Date
Hi Vinod,

When I thought that all corner cases are handled I got report of a failure on a
miss-configured setup:
UART without lines connected
Enable HW flow control (nothing is connected)
Do a small tx like "dd if=/dev/urandom of=/dev/ttyS1 bs=128 count=1"

The result is an interrupt flood caused by constant TDCM reception.

The explanation comes from the DMA split design and explained in patch 3:

"If the peripheral is disabled (or it is not able to send out data) the
UDMAP will complete a 'short' transfer. In other words: if the amount of
data can fit into PSI-L and PDMA (and peripheral FIFO) then UDMAP will
send out the data and return as the transfer is completed, however the
peripheral did not actually received all the data.

It was wrong to issue a normal teardown on the channel for several reasons:
UDMAP is not processing any packet so it will just return the TDCM and if
the peripheral is not consuming data from PDMA then we will have constant
flood of TDCMs (interrupts).
After the teardown the channel will be in reset state and we would need to
reset the rings as well, but it can not be done in interrupt context.
If the peripheral is just slow to consume data or even there is a delay
between starting the DMA then we will have again issues detecting the
state.

We could set force teardown, but that will make PDMA to discard the data
which is not correct in case of slow or delayed transfer start on the
peripheral.

The only solution is to use a work and check the progress in there after
the descriptor is returned and the UDMA and PDMA counters are not showing
the same number of bytes processed."

I'll squash these to v7, but I thought that this change is better to be visible
alone as it is kind of a big one on handling the early TX completion.

Regards,
Peter
---
Peter Ujfalusi (3):
dmaengine: ti: k3-udma: Correct completed descriptor's residue value
dmaengine: ti: k3-udma: Workaround for stale transfers
dmaengine: ti: k3-udma: Fix early TX completion against PDMAs

drivers/dma/ti/k3-udma.c | 89 +++++++++++++++++++++++++++++-----------
1 file changed, 66 insertions(+), 23 deletions(-)

--
Peter

Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki

\
 
 \ /
  Last update: 2019-12-02 21:32    [W:0.036 / U:0.412 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site