lkml.org 
[lkml]   [2019]   [Dec]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH v4 4/5] scsi: ufs: Do not clear the DL layer timers
Date

> During power mode change, PACP_PWR_Req frame sends
> PAPowerModeUserData parameters (and they are considered valid by device if
> Flags[4] - UserDataValid bit is set in the same frame).
> Currently we don't set these PAPowerModeUserData parameters and hardware
> always sets UserDataValid bit which would clear all the DL layer timeout values
> of the peer device after the power mode change.
>
> This change sets the PAPowerModeUserData[0..5] to UniPro specification
> recommended default values, in addition we are also setting the relevant
> DME_LOCAL_* timer attributes as required by UFS HCI specification.
>
> Signed-off-by: Can Guo <cang@codeaurora.org>
Reviewed-by: Avri Altman <avri.altman@wdc.com>

\
 
 \ /
  Last update: 2019-12-02 08:43    [W:0.059 / U:2.668 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site