lkml.org 
[lkml]   [2019]   [Dec]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCHv2] w1: omap-hdq: Simplify driver with PM runtime autosuspend
* Tony Lindgren <tony@atomide.com> [191216 14:54]:
> Vignesh, any comments on the ti,mode = "1w" and removal of the call to
> hdq_disable_interrupt()? Is there some specific section where we need
> to have interrupts disabled and then re-enabled?

OK I got "1w" mode working too now. We need to clear the irqstatus before
calling wait_event_timeout() on it, and we're now missing it in the
hdq_read_byte().

Looks like we should not tinker with the actual irstatus register though,
that's up to the hdq_isr() to manage.

So the following helper is probably what we want to do additionally.
I'll be posting v3 of the $subject patch.

Regards,

Tony

8< ----------------------
diff --git a/drivers/w1/masters/omap_hdq.c b/drivers/w1/masters/omap_hdq.c
--- a/drivers/w1/masters/omap_hdq.c
+++ b/drivers/w1/masters/omap_hdq.c
@@ -119,22 +119,24 @@ static int hdq_wait_for_flag(struct hdq_data *hdq_data, u32 offset,
return ret;
}

+/* Clear saved irqstatus after using an interrupt */
+static void hdq_reset_irqstatus(struct hdq_data *hdq_data)
+{
+ unsigned long irqflags;
+
+ spin_lock_irqsave(&hdq_data->hdq_spinlock, irqflags);
+ hdq_data->hdq_irqstatus = 0;
+ spin_unlock_irqrestore(&hdq_data->hdq_spinlock, irqflags);
+}
+
/* write out a byte and fill *status with HDQ_INT_STATUS */
static int hdq_write_byte(struct hdq_data *hdq_data, u8 val, u8 *status)
{
int ret;
u8 tmp_status;
- unsigned long irqflags;

*status = 0;

- spin_lock_irqsave(&hdq_data->hdq_spinlock, irqflags);
- /* clear interrupt flags via a dummy read */
- hdq_reg_in(hdq_data, OMAP_HDQ_INT_STATUS);
- /* ISR loads it with new INT_STATUS */
- hdq_data->hdq_irqstatus = 0;
- spin_unlock_irqrestore(&hdq_data->hdq_spinlock, irqflags);
-
hdq_reg_out(hdq_data, OMAP_HDQ_TX_DATA, val);

/* set the GO bit */
@@ -168,6 +170,7 @@ static int hdq_write_byte(struct hdq_data *hdq_data, u8 val, u8 *status)
}

out:
+ hdq_reset_irqstatus(hdq_data);
return ret;
}

@@ -219,7 +222,6 @@ static int omap_hdq_break(struct hdq_data *hdq_data)
{
int ret = 0;
u8 tmp_status;
- unsigned long irqflags;

ret = mutex_lock_interruptible(&hdq_data->hdq_mutex);
if (ret < 0) {
@@ -228,13 +230,6 @@ static int omap_hdq_break(struct hdq_data *hdq_data)
goto rtn;
}

- spin_lock_irqsave(&hdq_data->hdq_spinlock, irqflags);
- /* clear interrupt flags via a dummy read */
- hdq_reg_in(hdq_data, OMAP_HDQ_INT_STATUS);
- /* ISR loads it with new INT_STATUS */
- hdq_data->hdq_irqstatus = 0;
- spin_unlock_irqrestore(&hdq_data->hdq_spinlock, irqflags);
-
/* set the INIT and GO bit */
hdq_reg_merge(hdq_data, OMAP_HDQ_CTRL_STATUS,
OMAP_HDQ_CTRL_STATUS_INITIALIZATION | OMAP_HDQ_CTRL_STATUS_GO,
@@ -283,6 +278,7 @@ static int omap_hdq_break(struct hdq_data *hdq_data)
" return to zero, %x", tmp_status);

out:
+ hdq_reset_irqstatus(hdq_data);
mutex_unlock(&hdq_data->hdq_mutex);
rtn:
return ret;
@@ -330,6 +326,7 @@ static int hdq_read_byte(struct hdq_data *hdq_data, u8 *val)
/* the data is ready. Read it in! */
*val = hdq_reg_in(hdq_data, OMAP_HDQ_RX_DATA);
out:
+ hdq_reset_irqstatus(hdq_data);
mutex_unlock(&hdq_data->hdq_mutex);
rtn:
return ret;
@@ -363,7 +360,6 @@ static u8 omap_w1_triplet(void *_hdq, u8 bdir)
goto rtn;
}

- hdq_data->hdq_irqstatus = 0;
/* read id_bit */
hdq_reg_merge(_hdq, OMAP_HDQ_CTRL_STATUS,
ctrl | OMAP_HDQ_CTRL_STATUS_DIR, mask);
@@ -377,7 +373,9 @@ static u8 omap_w1_triplet(void *_hdq, u8 bdir)
}
id_bit = (hdq_reg_in(_hdq, OMAP_HDQ_RX_DATA) & 0x01);

- hdq_data->hdq_irqstatus = 0;
+ /* Must clear irqstatus for another RXCOMPLETE interrupt */
+ hdq_reset_irqstatus(hdq_data);
+
/* read comp_bit */
hdq_reg_merge(_hdq, OMAP_HDQ_CTRL_STATUS,
ctrl | OMAP_HDQ_CTRL_STATUS_DIR, mask);
@@ -420,6 +418,7 @@ static u8 omap_w1_triplet(void *_hdq, u8 bdir)
OMAP_HDQ_CTRL_STATUS_SINGLE);

out:
+ hdq_reset_irqstatus(hdq_data);
mutex_unlock(&hdq_data->hdq_mutex);
rtn:
pm_runtime_mark_last_busy(hdq_data->dev);
@@ -460,7 +459,7 @@ static u8 omap_w1_read_byte(void *_hdq)
if (ret < 0) {
pm_runtime_put_noidle(hdq_data->dev);

- return ret;
+ return -1;
}

ret = hdq_read_byte(hdq_data, &val);
--
2.24.1
\
 
 \ /
  Last update: 2019-12-16 17:44    [W:0.063 / U:0.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site