lkml.org 
[lkml]   [2019]   [Dec]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 5.4 79/92] spi: Fix SPI_CS_HIGH setting when using native and GPIO CS
Date
From: Gregory CLEMENT <gregory.clement@bootlin.com>

commit 3e5ec1db8bfee845d9f8560d1c64aeaccd586398 upstream.

When improving the CS GPIO support at core level, the SPI_CS_HIGH
has been enabled for all the CS lines used for a given SPI controller.

However, the SPI framework allows to have on the same controller native
CS and GPIO CS. The native CS may not support the SPI_CS_HIGH, so they
should not be setup automatically.

With this patch the setting is done only for the CS that will use a
GPIO as CS

Fixes: f3186dd87669 ("spi: Optionally use GPIO descriptors for CS GPIOs")
Cc: <stable@vger.kernel.org>
Signed-off-by: Gregory CLEMENT <gregory.clement@bootlin.com>
Link: https://lore.kernel.org/r/20191018152929.3287-1-gregory.clement@bootlin.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

---
drivers/spi/spi.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)

--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -1711,15 +1711,7 @@ static int of_spi_parse_dt(struct spi_co
spi->mode |= SPI_3WIRE;
if (of_property_read_bool(nc, "spi-lsb-first"))
spi->mode |= SPI_LSB_FIRST;
-
- /*
- * For descriptors associated with the device, polarity inversion is
- * handled in the gpiolib, so all chip selects are "active high" in
- * the logical sense, the gpiolib will invert the line if need be.
- */
- if (ctlr->use_gpio_descriptors)
- spi->mode |= SPI_CS_HIGH;
- else if (of_property_read_bool(nc, "spi-cs-high"))
+ if (of_property_read_bool(nc, "spi-cs-high"))
spi->mode |= SPI_CS_HIGH;

/* Device DUAL/QUAD mode */
@@ -1783,6 +1775,14 @@ static int of_spi_parse_dt(struct spi_co
}
spi->chip_select = value;

+ /*
+ * For descriptors associated with the device, polarity inversion is
+ * handled in the gpiolib, so all gpio chip selects are "active high"
+ * in the logical sense, the gpiolib will invert the line if need be.
+ */
+ if ((ctlr->use_gpio_descriptors) && ctlr->cs_gpiods[spi->chip_select])
+ spi->mode |= SPI_CS_HIGH;
+
/* Device speed */
rc = of_property_read_u32(nc, "spi-max-frequency", &value);
if (rc) {

\
 
 \ /
  Last update: 2019-12-11 17:12    [W:0.472 / U:3.168 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site