lkml.org 
[lkml]   [2019]   [Nov]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] ARM: dts: ls1021a-tsn: Use interrupts for the SGMII PHYs
On Sat, Nov 09, 2019 at 08:52:54PM +0100, Alexander Stein wrote:
> On Saturday, November 9, 2019, 4:21:51 PM CET Vladimir Oltean wrote:
> > On 09/11/2019, Andrew Lunn <andrew@lunn.ch> wrote:
> > > On Sat, Nov 09, 2019 at 12:56:42PM +0200, Vladimir Oltean wrote:
> > >> On the LS1021A-TSN board, the 2 Atheros AR8031 PHYs for eth0 and eth1
> > >> have interrupt lines connected to the shared IRQ2_B LS1021A pin.
> > >>
> > >> The interrupts are active low, but the GICv2 controller does not support
> > >> active-low and falling-edge interrupts, so the only mode it can be
> > >> configured in is rising-edge.
> > >
> > > Hi Vladimir
> > >
> > > So how does this work? The rising edge would occur after the interrupt
> > > handler has completed? What triggers the interrupt handler?
> > >
> > > Andrew
> > >
> >
> > Hi Andrew,
> >
> > I hope I am not terribly confused about this. I thought I am telling
> > the interrupt controller to raise an IRQ as a result of the
> > low-to-high transition of the electrical signal. Experimentation sure
> > seems to agree with me. So the IRQ is generated immediately _after_
> > the PHY has left the line in open drain and it got pulled up to Vdd.
>

> It is correct GIC only supports raising edge and active-high. The
> IRQ[0:5] on ls1021a are a bit special though. They not directly
> connected to GIC, but there is an optional inverter, enabled by
> default.

Ah, O.K. So configuring for a rising edge is actually giving a falling
edge. Which is why it works.

Actually supporting this correctly is going a cause some pain. I
wonder how many DT files currently say rising/active high, when in
fact falling/active low is actually being used? And when the IRQ
controller really does support active low and falling, things brake?

Vladimir, since this is a shared interrupt, you really should use
active low here. Maybe the first step is to get control of the
inverter, and define a DT binding which is not going to break
backwards compatibility. And then wire up this interrupt.

Andrew

\
 
 \ /
  Last update: 2019-11-09 22:06    [W:0.051 / U:0.536 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site