lkml.org 
[lkml]   [2019]   [Nov]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[Patch v2 01/20] dt-bindings: media: cal: update binding to use syscon
    Date
    Update Device Tree bindings for the CAL driver to use syscon to access
    the phy config register instead of trying to map it directly.

    Signed-off-by: Benoit Parrot <bparrot@ti.com>
    ---
    Documentation/devicetree/bindings/media/ti-cal.txt | 14 +++++++++-----
    1 file changed, 9 insertions(+), 5 deletions(-)

    diff --git a/Documentation/devicetree/bindings/media/ti-cal.txt b/Documentation/devicetree/bindings/media/ti-cal.txt
    index ae9b52f37576..93096d924786 100644
    --- a/Documentation/devicetree/bindings/media/ti-cal.txt
    +++ b/Documentation/devicetree/bindings/media/ti-cal.txt
    @@ -10,9 +10,14 @@ Required properties:
    - compatible: must be "ti,dra72-cal"
    - reg: CAL Top level, Receiver Core #0, Receiver Core #1 and Camera RX
    control address space
    -- reg-names: cal_top, cal_rx_core0, cal_rx_core1, and camerrx_control
    +- reg-names: cal_top, cal_rx_core0, cal_rx_core1 and camerrx_control
    registers
    - interrupts: should contain IRQ line for the CAL;
    +- ti,camerrx-control: phandle to the device control module and offset to
    + the control_camerarx_core register.
    + This node is meant to replace the "camerrx_control"
    + reg entry above but "camerrx_control" is still
    + handled for backward compatibility.

    CAL supports 2 camera port nodes on MIPI bus. Each CSI2 camera port nodes
    should contain a 'port' child node with child 'endpoint' node. Please
    @@ -25,13 +30,12 @@ Example:
    ti,hwmods = "cal";
    reg = <0x4845B000 0x400>,
    <0x4845B800 0x40>,
    - <0x4845B900 0x40>,
    - <0x4A002e94 0x4>;
    + <0x4845B900 0x40>;
    reg-names = "cal_top",
    "cal_rx_core0",
    - "cal_rx_core1",
    - "camerrx_control";
    + "cal_rx_core1";
    interrupts = <GIC_SPI 119 IRQ_TYPE_LEVEL_HIGH>;
    + ti,camerrx-control = <&scm_conf 0xE94>;
    #address-cells = <1>;
    #size-cells = <0>;

    --
    2.17.1
    \
     
     \ /
      Last update: 2019-11-04 20:33    [W:2.301 / U:0.532 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site