lkml.org 
[lkml]   [2019]   [Nov]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/3] arm64: dts: allwinner: a64: olinuxino: Fix eMMC supply regulator
Date
A64-OLinuXino-eMMC uses 1.8V for eMMC supply. This is done via a triple
jumper, which sets VCC-PL to either 1.8V or 3.3V. This setting is different
for boards with and without eMMC.

This is not a big issue for DDR52 mode, however the eMMC will not work in
HS200/HS400, since these modes explicitly requires 1.8V.

Fixes: 94f68f3a4b2a ("arm64: dts: allwinner: a64: Add A64 OlinuXino board (with eMMC)")
Cc: stable@vger.kernel.org # v5.4
Signed-off-by: Stefan Mavrodiev <stefan@olimex.com>
---
Changes for v2:
- Restore the original eMMC vmmc-supply property

arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
index 96ab0227e82d..121e6cc4849b 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
@@ -15,7 +15,7 @@
pinctrl-names = "default";
pinctrl-0 = <&mmc2_pins>;
vmmc-supply = <&reg_dcdc1>;
- vqmmc-supply = <&reg_dcdc1>;
+ vqmmc-supply = <&reg_eldo1>;
bus-width = <8>;
non-removable;
cap-mmc-hw-reset;
--
2.17.1
\
 
 \ /
  Last update: 2019-11-29 12:41    [W:0.085 / U:0.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site