lkml.org 
[lkml]   [2019]   [Nov]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [linux-sunxi] [PATCH 1/3] arm64: dts: allwinner: a64: olinuxino: Fix eMMC supply regulator
From
Date

On 11/29/19 11:26 AM, Chen-Yu Tsai wrote:
> On Fri, Nov 29, 2019 at 5:14 PM Stefan Mavrodiev <stefan@olimex.com> wrote:
>> A64-OLinuXino-eMMC uses 1.8V for eMMC supply. This is done via a triple
>> jumper, which sets VCC-PL to either 1.8V or 3.3V. This setting is different
>> for boards with and without eMMC.
>>
>> This is not a big issue for DDR52 mode, however the eMMC will not work in
>> HS200/HS400, since these modes explicitly requires 1.8V.
>>
>> Signed-off-by: Stefan Mavrodiev <stefan@olimex.com>
>> ---
>> arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts | 4 ++--
>> 1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
>> index 96ab0227e82d..7d135decbd53 100644
>> --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
>> +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
>> @@ -14,8 +14,8 @@
>> &mmc2 {
>> pinctrl-names = "default";
>> pinctrl-0 = <&mmc2_pins>;
>> - vmmc-supply = <&reg_dcdc1>;
>> - vqmmc-supply = <&reg_dcdc1>;
>> + vmmc-supply = <&reg_eldo1>;
> If I'm reading the schematics correctly, VCC on the eMMC is from 3.3V.
> This corresponds to the vmmc-supply property. So you shouldn't change it.

My bad. Don't know how I've missed that.

Stefan

>
>> + vqmmc-supply = <&reg_eldo1>;
> vqmmc-supply is from the VCC-PC rail, which is the one you say is triple-
> jumpered. So this change makes sense.
>
> ChenYu
>

\
 
 \ /
  Last update: 2019-11-29 10:51    [W:0.030 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site