lkml.org 
[lkml]   [2019]   [Nov]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 3/4] dt-bindings: pinctrl: Add bindings for Ingenic X1830.
Date
Add the pinctrl bindings for the X1830 Soc from Ingenic.

Signed-off-by: Zhou Yanjie <zhouyanjie@zoho.com>
---
Documentation/devicetree/bindings/pinctrl/ingenic,pinctrl.txt | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/pinctrl/ingenic,pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/ingenic,pinctrl.txt
index 0014d98..d9b2100 100644
--- a/Documentation/devicetree/bindings/pinctrl/ingenic,pinctrl.txt
+++ b/Documentation/devicetree/bindings/pinctrl/ingenic,pinctrl.txt
@@ -10,9 +10,9 @@ GPIO port configuration registers and it is typical to refer to pins using the
naming scheme "PxN" where x is a character identifying the GPIO port with
which the pin is associated and N is an integer from 0 to 31 identifying the
pin within that GPIO port. For example PA0 is the first pin in GPIO port A, and
-PB31 is the last pin in GPIO port B. The jz4740 and the x1000 contains 4 GPIO
-ports, PA to PD, for a total of 128 pins. The jz4760, the jz4770 and the jz4780
-contains 6 GPIO ports, PA to PF, for a total of 192 pins.
+PB31 is the last pin in GPIO port B. The jz4740, the x1000 and the x1830
+contains 4 GPIO ports, PA to PD, for a total of 128 pins. The jz4760, the
+jz4770 and the jz4780 contains 6 GPIO ports, PA to PF, for a total of 192 pins.


Required properties:
@@ -28,6 +28,7 @@ Required properties:
- "ingenic,x1000-pinctrl"
- "ingenic,x1000e-pinctrl"
- "ingenic,x1500-pinctrl"
+ - "ingenic,x1830-pinctrl"
- reg: Address range of the pinctrl registers.


@@ -40,6 +41,7 @@ Required properties for sub-nodes (GPIO chips):
- "ingenic,jz4770-gpio"
- "ingenic,jz4780-gpio"
- "ingenic,x1000-gpio"
+ - "ingenic,x1830-gpio"
- reg: The GPIO bank number.
- interrupt-controller: Marks the device node as an interrupt controller.
- interrupts: Interrupt specifier for the controllers interrupt.
--
2.7.4

\
 
 \ /
  Last update: 2019-11-20 15:01    [W:1.340 / U:0.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site