Messages in this thread Patch in this message | | | From | Bjorn Andersson <> | Subject | [PATCH v2 2/5] phy: qcom-qmp: Increase PHY ready timeout | Date | Fri, 1 Nov 2019 17:16:25 -0700 |
| |
It's typical for the QHP PHY to take slightly above 1ms to initialize, so increase the timeout of the PHY ready check to 10ms - as already done in the downstream PCIe driver.
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org> ---
Changes since v1: - New patch
drivers/phy/qualcomm/phy-qcom-qmp.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c index 091e20303a14..66f91726b8b2 100644 --- a/drivers/phy/qualcomm/phy-qcom-qmp.c +++ b/drivers/phy/qualcomm/phy-qcom-qmp.c @@ -66,7 +66,7 @@ /* QPHY_V3_PCS_MISC_CLAMP_ENABLE register bits */ #define CLAMP_EN BIT(0) /* enables i/o clamp_n */ -#define PHY_INIT_COMPLETE_TIMEOUT 1000 +#define PHY_INIT_COMPLETE_TIMEOUT 10000 #define POWER_DOWN_DELAY_US_MIN 10 #define POWER_DOWN_DELAY_US_MAX 11 -- 2.23.0
| |