Messages in this thread | | | From | Linus Walleij <> | Date | Mon, 21 Oct 2019 02:57:31 +0200 | Subject | Re: [PATCH v2 3/4] gpio: Add RDA Micro GPIO controller support |
| |
On Sat, Oct 19, 2019 at 6:05 PM Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> wrote: > On Wed, Oct 16, 2019 at 02:41:32PM +0200, Linus Walleij wrote:
> > select GPIO_GENERIC > > hmm.. I don't think this driver can use it. Please see the justification > below. (...) > As you can see in this driver, there are 2 separate registers needs to be > read in order to get the value. RDA_GPIO_VAL needs to be read when the pin > is in input state and RDA_GPIO_SET needs to be read when the pin is in output > state. > > The MMIO driver relies on a single `dat` register to read the GPIO state and > this won't fit for this driver and hence my justification for not using it.
Use RDA_GPIO_VAL for dat, then set BGPIOF_READ_OUTPUT_REG_SET and the mmio core will do what you want I think? That's what the flag is for IIUC.
Maybe we should document it better :/
Yours, Linus Walleij
| |