[lkml]   [2019]   [Oct]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH 0/7] Introduce max12xx ADC support
Hello, here is a patchset updating the existing max1027.c driver (for
10-bit max1027/29/31 ADCs) with a few corrections/improvements and
then introducing their 12-bit cousins named max1227/29/31.

As on my hardware setup the "start conversion" and "end of conversion"
pin are not wired (which is absolutely fine for this chip), I also
updated the driver and the bindings to support optional interrupts. In
this case, triggered buffers are not available and the user must poll
the value from sysfs.


Miquel Raynal (7):
iio: adc: max1027: Add debugfs register read support
iio: adc: max1027: Make it optional to use interrupts
iio: adc: max1027: Reset the device at probe time
iio: adc: max1027: Prepare the introduction of different resolutions
iio: adc: max1027: Introduce 12-bit devices support
dt-bindings: iio: adc: max1027: Mark interrupts as optional
dt-bindings: iio: adc: max1027: Document max12xx series compatibles

.../bindings/iio/adc/max1027-adc.txt | 12 +-
drivers/iio/adc/Kconfig | 4 +-
drivers/iio/adc/max1027.c | 190 +++++++++++-------
3 files changed, 133 insertions(+), 73 deletions(-)


 \ /
  Last update: 2019-10-02 14:31    [W:0.040 / U:28.744 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site