lkml.org 
[lkml]   [2019]   [Oct]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 5.3 009/112] xhci: Check all endpoints for LPM timeout
Date
From: Jan Schmidt <jan@centricular.com>

commit d500c63f80f2ea08ee300e57da5f2af1c13875f5 upstream.

If an endpoint is encountered that returns USB3_LPM_DEVICE_INITIATED, keep
checking further endpoints, as there might be periodic endpoints later
that return USB3_LPM_DISABLED due to shorter service intervals.

Without this, the code can set too high a maximum-exit-latency and
prevent the use of multiple USB3 cameras that should be able to work.

Cc: <stable@vger.kernel.org>
Signed-off-by: Jan Schmidt <jan@centricular.com>
Tested-by: Philipp Zabel <p.zabel@pengutronix.de>
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Link: https://lore.kernel.org/r/1570190373-30684-4-git-send-email-mathias.nyman@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

---
drivers/usb/host/xhci.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -4673,12 +4673,12 @@ static int xhci_update_timeout_for_endpo
alt_timeout = xhci_call_host_update_timeout_for_endpoint(xhci, udev,
desc, state, timeout);

- /* If we found we can't enable hub-initiated LPM, or
+ /* If we found we can't enable hub-initiated LPM, and
* the U1 or U2 exit latency was too high to allow
- * device-initiated LPM as well, just stop searching.
+ * device-initiated LPM as well, then we will disable LPM
+ * for this device, so stop searching any further.
*/
- if (alt_timeout == USB3_LPM_DISABLED ||
- alt_timeout == USB3_LPM_DEVICE_INITIATED) {
+ if (alt_timeout == USB3_LPM_DISABLED) {
*timeout = alt_timeout;
return -E2BIG;
}

\
 
 \ /
  Last update: 2019-10-16 23:59    [W:1.708 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site