lkml.org 
[lkml]   [2019]   [Oct]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] PCI/PM: Note that PME can be generated from D0
Date
From: Bjorn Helgaas <bhelgaas@google.com>

Per PCIe r5.0 sec 7.5.2.1, PME may be generated from D0, so update
Documentation/power/pci.rst to reflect that.

Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
---
Documentation/power/pci.rst | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/power/pci.rst b/Documentation/power/pci.rst
index db41a770a2f5..a90e82c70a3b 100644
--- a/Documentation/power/pci.rst
+++ b/Documentation/power/pci.rst
@@ -130,8 +130,8 @@ a full power-on reset sequence and the power-on defaults are restored to the
device by hardware just as at initial power up.

PCI devices supporting the PCI PM Spec can be programmed to generate PMEs
-while in a low-power state (D1-D3), but they are not required to be capable
-of generating PMEs from all supported low-power states. In particular, the
+while in any power state (D0-D3), but they are not required to be capable
+of generating PMEs from all supported power states. In particular, the
capability of generating PMEs from D3cold is optional and depends on the
presence of additional voltage (3.3Vaux) allowing the device to remain
sufficiently active to generate a wakeup signal.
--
2.23.0.700.g56cf767bdb-goog
\
 
 \ /
  Last update: 2019-10-16 21:45    [W:0.054 / U:0.396 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site