lkml.org 
[lkml]   [2019]   [Jan]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 0/4] /proc/stat: Reduce irqs counting performance overhead
From
Date
On 01/09/2019 01:24 PM, Matthew Wilcox wrote:
> On Wed, Jan 09, 2019 at 01:03:33PM -0500, Waiman Long wrote:
>> The paragraph above may be a bit misleading. This v2 patch actually
>> touches very little on percpu accounting aspect of the IRQ counts. See
>> patches 2 and 3 for the relevant changes which is just a few line of new
>> codes. Please review the individual patches before Nak'ing.
>>
>> I could theoretically generalize them into a new set of percpu counting
>> helpers, but the idea behind it is quite different from the use cases of
>> percpu counter. So it may not be a good idea of adding it to there.
> Did you even try just using the general purpose infrastructure that's
> in place? If that shows a performance problem _then_ it's time to make
> this special snowflake just a little more special. Not before.

I have looked into the percpu counter code. There are two aspects that I
don't like to introduce to the interrupt handler's code path for
updating the counts.

1) There is a raw spinlock in the percpu_counter structure that may need
to be acquired in the update path. This can be a performance drag
especially if lockdep is enabled.

2) The percpu_counter structure is 40 bytes in size on 64-bit systems
compared with just 8 bytes for the percpu count pointer and an
additional 4 bytes that I introduced in patch 2. With thousands of irq
descriptors, it can consume quite a lot more memory. Memory consumption
was a point that you brought up in one of your previous mails.

Cheers,
Longman


\
 
 \ /
  Last update: 2019-01-09 19:38    [W:0.204 / U:0.620 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site