lkml.org 
[lkml]   [2019]   [Jan]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
SubjectRe: [RFC PATCH 4/4] x86/mm: remove bottom-up allocation style for x86_64
On Tue, Jan 8, 2019 at 1:42 AM Dave Hansen <dave.hansen@intel.com> wrote:
>
> On 1/7/19 12:24 AM, Pingfan Liu wrote:
> > There are two acheivements by this patch.
> > -1st. keep the subtree of pgtable away from movable node.
> > Background about the defect of the current bottom-up allocation style, take
> > the following scenario:
> > | unmovable node | movable node |
> > | kaslr-kernel |subtree of pgtable for phy<->virt |
>
>
>
> > Although kaslr-kernel can avoid to stain the movable node. [1] But the
> > pgtable can still stain the movable node. That is a probability problem,
> > with low probability, but still exist. This patch tries to eliminate the
> > probability. With the previous patch, at the point of init_mem_mapping(),
> > memblock allocator can work with the knowledge of acpi memory hotmovable
> > info, and avoid to stain the movable node. As a result,
> > memory_map_bottom_up() is not needed any more.
> >
> > -2nd. simplify the logic of memory_map_top_down()
> > Thanks to the help of early_make_pgtable(), x86_64 can directly set up the
> > subtree of pgtable at any place, hence the careful iteration in
> > memory_map_top_down() can be discard.
>
> > void __init init_mem_mapping(void)
> > {
> > unsigned long end;
> > @@ -663,6 +540,7 @@ void __init init_mem_mapping(void)
> >
> > #ifdef CONFIG_X86_64
> > end = max_pfn << PAGE_SHIFT;
> > + set_alloc_range(0x100000, end);
> > #else
>
> Why is this 0x100000 open-coded? Why is this needed *now*?
>

Memory under 1MB should be used by BIOS. For x86_64, after
e820__memblock_setup(), the memblock allocator has already been ready
to work. But there are two factors to in order to
set_alloc_range(0x100000, end). The major one is to be compatible with
x86_32, please refer to alloc_low_pages->memblock_find_in_range() uses
[min_pfn_mapped, max_pfn_mapped] to limit the range, which is ready to
be allocated from. The minor one is to prevent unexpected allocation
from memblock allocator through allow_low_pages() at very early stage.
>
> > /*
> > * If the allocation is in bottom-up direction, we setup direct mapping
> > * in bottom-up, otherwise we setup direct mapping in top-down.
> > @@ -692,13 +577,6 @@ void __init init_mem_mapping(void)
> > } else {
> > memory_map_top_down(ISA_END_ADDRESS, end);
> > }
> > -
> > -#ifdef CONFIG_X86_64
> > - if (max_pfn > max_low_pfn) {
> > - /* can we preseve max_low_pfn ?*/
> > - max_low_pfn = max_pfn;
> > - }
> > -#else
> > early_ioremap_page_table_range_init();
> > #endif
> >
> > diff --git a/arch/x86/mm/init_32.c b/arch/x86/mm/init_32.c
> > index 85c94f9..ecf7243 100644
> > --- a/arch/x86/mm/init_32.c
> > +++ b/arch/x86/mm/init_32.c
> > @@ -58,6 +58,8 @@ unsigned long highstart_pfn, highend_pfn;
> >
> > bool __read_mostly __vmalloc_start_set = false;
> >
> > +static unsigned long min_pfn_mapped;
> > +
> > /*
> > * Creates a middle page table and puts a pointer to it in the
> > * given global directory entry. This only returns the gd entry
> > @@ -516,6 +518,127 @@ void __init native_pagetable_init(void)
> > paging_init();
> > }
> >
> > +static unsigned long __init get_new_step_size(unsigned long step_size)
> > +{
> > + /*
> > + * Initial mapped size is PMD_SIZE (2M).
> > + * We can not set step_size to be PUD_SIZE (1G) yet.
> > + * In worse case, when we cross the 1G boundary, and
> > + * PG_LEVEL_2M is not set, we will need 1+1+512 pages (2M + 8k)
> > + * to map 1G range with PTE. Hence we use one less than the
> > + * difference of page table level shifts.
> > + *
> > + * Don't need to worry about overflow in the top-down case, on 32bit,
> > + * when step_size is 0, round_down() returns 0 for start, and that
> > + * turns it into 0x100000000ULL.
> > + * In the bottom-up case, round_up(x, 0) returns 0 though too, which
> > + * needs to be taken into consideration by the code below.
> > + */
> > + return step_size << (PMD_SHIFT - PAGE_SHIFT - 1);
> > +}
> > +
> > +/**
> > + * memory_map_top_down - Map [map_start, map_end) top down
> > + * @map_start: start address of the target memory range
> > + * @map_end: end address of the target memory range
> > + *
> > + * This function will setup direct mapping for memory range
> > + * [map_start, map_end) in top-down. That said, the page tables
> > + * will be allocated at the end of the memory, and we map the
> > + * memory in top-down.
> > + */
> > +void __init memory_map_top_down(unsigned long map_start,
> > + unsigned long map_end)
> > +{
> > + unsigned long real_end, start, last_start;
> > + unsigned long step_size;
> > + unsigned long addr;
> > + unsigned long mapped_ram_size = 0;
> > +
> > + /* xen has big range in reserved near end of ram, skip it at first.*/
> > + addr = memblock_find_in_range(map_start, map_end, PMD_SIZE, PMD_SIZE);
> > + real_end = addr + PMD_SIZE;
> > +
> > + /* step_size need to be small so pgt_buf from BRK could cover it */
> > + step_size = PMD_SIZE;
> > + max_pfn_mapped = 0; /* will get exact value next */
> > + min_pfn_mapped = real_end >> PAGE_SHIFT;
> > + last_start = start = real_end;
> > +
> > + /*
> > + * We start from the top (end of memory) and go to the bottom.
> > + * The memblock_find_in_range() gets us a block of RAM from the
> > + * end of RAM in [min_pfn_mapped, max_pfn_mapped) used as new pages
> > + * for page table.
> > + */
> > + while (last_start > map_start) {
> > + if (last_start > step_size) {
> > + start = round_down(last_start - 1, step_size);
> > + if (start < map_start)
> > + start = map_start;
> > + } else
> > + start = map_start;
> > + mapped_ram_size += init_range_memory_mapping(start,
> > + last_start);
> > + set_alloc_range(min_pfn_mapped, max_pfn_mapped);
> > + last_start = start;
> > + min_pfn_mapped = last_start >> PAGE_SHIFT;
> > + if (mapped_ram_size >= step_size)
> > + step_size = get_new_step_size(step_size);
> > + }
> > +
> > + if (real_end < map_end) {
> > + init_range_memory_mapping(real_end, map_end);
> > + set_alloc_range(min_pfn_mapped, max_pfn_mapped);
> > + }
> > +}
> > +
> > +/**
> > + * memory_map_bottom_up - Map [map_start, map_end) bottom up
> > + * @map_start: start address of the target memory range
> > + * @map_end: end address of the target memory range
> > + *
> > + * This function will setup direct mapping for memory range
> > + * [map_start, map_end) in bottom-up. Since we have limited the
> > + * bottom-up allocation above the kernel, the page tables will
> > + * be allocated just above the kernel and we map the memory
> > + * in [map_start, map_end) in bottom-up.
> > + */
> > +void __init memory_map_bottom_up(unsigned long map_start,
> > + unsigned long map_end)
> > +{
> > + unsigned long next, start;
> > + unsigned long mapped_ram_size = 0;
> > + /* step_size need to be small so pgt_buf from BRK could cover it */
> > + unsigned long step_size = PMD_SIZE;
> > +
> > + start = map_start;
> > + min_pfn_mapped = start >> PAGE_SHIFT;
> > +
> > + /*
> > + * We start from the bottom (@map_start) and go to the top (@map_end).
> > + * The memblock_find_in_range() gets us a block of RAM from the
> > + * end of RAM in [min_pfn_mapped, max_pfn_mapped) used as new pages
> > + * for page table.
> > + */
> > + while (start < map_end) {
> > + if (step_size && map_end - start > step_size) {
> > + next = round_up(start + 1, step_size);
> > + if (next > map_end)
> > + next = map_end;
> > + } else {
> > + next = map_end;
> > + }
> > +
> > + mapped_ram_size += init_range_memory_mapping(start, next);
> > + set_alloc_range(min_pfn_mapped, max_pfn_mapped);
> > + start = next;
> > +
> > + if (mapped_ram_size >= step_size)
> > + step_size = get_new_step_size(step_size);
> > + }
> > +}
>
> One more suggestion: Can you *move* the code in a separate patch?
> Un-use it in this patch, but wait for one more patch to actually move it.
>

Good suggestion. It will make it easier to review. I will do it in next version
> > /*
> > * Build a proper pagetable for the kernel mappings. Up until this
> > * point, we've been running on some set of pagetables constructed by
> > diff --git a/arch/x86/mm/mm_internal.h b/arch/x86/mm/mm_internal.h
> > index 319bde3..28006de 100644
> > --- a/arch/x86/mm/mm_internal.h
> > +++ b/arch/x86/mm/mm_internal.h
> > @@ -8,6 +8,13 @@ static inline void *alloc_low_page(void)
> > return alloc_low_pages(1);
> > }
> >
> > +unsigned long __init init_range_memory_mapping(unsigned long r_start,
> > + unsigned long r_end);
> > +void set_alloc_range(unsigned long low, unsigned long high);
> > +void __init memory_map_top_down(unsigned long map_start,
> > + unsigned long map_end);
> > +void __init memory_map_bottom_up(unsigned long map_start,
> > + unsigned long map_end);
>
> Is there a reason we can't just move all these calls into init_32.c?
>
> Seems like we probably just want one, new function, like:
>
> init_mem_mapping_x86_32(end);
>
> And then we just export *that* instead of exporting all of these helpers
> that only get used on x86_32. It also makes init_mem_mapping() more
> readable since the #ifdef's are shorter.

Yes, I will do like this.

Thanks for your kindly review.

Regards,
Pingfan

\
 
 \ /
  Last update: 2019-01-08 07:14    [W:0.088 / U:2.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site