lkml.org 
[lkml]   [2019]   [Jan]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v1 2/6] clk: qcom: Skip halt checks on gcc_usb3_phy_pipe_clk for 8998
Date
The gcc_usb3_phy_pipe_clk is generated by the phy, but is also used by
the phy during init. The clock needs to be enabled during the init
sequence, but may not be fully active until after the init sequence is
complete. This causes a catch-22 if the clock status is checked during
enable. As a result, skip the checks to avoid the troubling situation.

Signed-off-by: Jeffrey Hugo <jhugo@codeaurora.org>
---
drivers/clk/qcom/gcc-msm8998.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/clk/qcom/gcc-msm8998.c b/drivers/clk/qcom/gcc-msm8998.c
index 42de947..1a1806a 100644
--- a/drivers/clk/qcom/gcc-msm8998.c
+++ b/drivers/clk/qcom/gcc-msm8998.c
@@ -2496,7 +2496,7 @@ enum {

static struct clk_branch gcc_usb3_phy_pipe_clk = {
.halt_reg = 0x50004,
- .halt_check = BRANCH_HALT,
+ .halt_check = BRANCH_HALT_SKIP,
.clkr = {
.enable_reg = 0x50004,
.enable_mask = BIT(0),
--
Qualcomm Datacenter Technologies as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.
\
 
 \ /
  Last update: 2019-01-04 17:51    [W:0.040 / U:0.276 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site