lkml.org 
[lkml]   [2019]   [Jan]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH] kcov: convert kcov.refcount to refcount_t
Date
> On Thu, Jan 31, 2019 at 11:04 AM Reshetova, Elena
> <elena.reshetova@intel.com> wrote:
> >
> > > Just to check, has this been tested with CONFIG_REFCOUNT_FULL and
> > > > something poking kcov?
> > > >
> > > > Given lib/refcount.c is instrumented, the refcount_*() calls will
> > > > recurse back into the kcov code. It looks like that's fine, given these
> > > > are only manipulated in setup/teardown paths, but it would be nice to be
> > > > sure.
> > >
> > > A simple program using KCOV is available here:
> > > https://elixir.bootlin.com/linux/v5.0-rc3/source/Documentation/dev-
> > > tools/kcov.rst#L42
> > > or here (it's like strace but collects and prints KCOV coverage):
> > > https://github.com/google/syzkaller/blob/master/tools/kcovtrace/kcovtrace.c
> > >
> >
> > Ok, so I finally got to compile kcov in and try the first test program
> > and it works fine as far as I can see: runs, prints results, and no WARNs anywhere
> > visible with regards to refcount_t.
> >
> > I did my test on 4.20 with CONFIG_REFCOUNT_FULL=y
> > since I have serious issues getting 5.0 running as it is even from
> > the stable branch, but unless kcov underwent some serious changes since
> December,
> > it should not affect.
>
> There were no changes that should affect this part.
>
> Reviewed-by: Dmitry Vyukov <dvyukov@google.com>


Thank you! Will you be able to take this change forward as for
other normal kcov changes?

Best Regards,
Elena.
\
 
 \ /
  Last update: 2019-01-31 11:10    [W:0.918 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site