lkml.org 
[lkml]   [2019]   [Jan]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v5 2/2] spi-atmel: support inter-word delay
Date
On 29/01/2019 at 21:55, Jonas Bonn wrote:
> If the SPI slave requires an inter-word delay, configure the DLYBCT
> register accordingly.
>
> Tested on a SAMA5D2 board (derived from SAMA5D2-Xplained reference
> board).
>
> Signed-off-by: Jonas Bonn <jonas@norrbonn.se>
> CC: Nicolas Ferre <nicolas.ferre@microchip.com>
> CC: Mark Brown <broonie@kernel.org>
> CC: Alexandre Belloni <alexandre.belloni@bootlin.com>
> CC: Ludovic Desroches <ludovic.desroches@microchip.com>
> CC: linux-spi@vger.kernel.org
> CC: linux-arm-kernel@lists.infradead.org
> ---
> drivers/spi/spi-atmel.c | 11 ++++++-----
> 1 file changed, 6 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
> index f53f0c5e63da..57cc7110f9e8 100644
> --- a/drivers/spi/spi-atmel.c
> +++ b/drivers/spi/spi-atmel.c
> @@ -1201,13 +1201,14 @@ static int atmel_spi_setup(struct spi_device *spi)
> csr |= SPI_BIT(CSAAT);
>
> /* DLYBS is mostly irrelevant since we manage chipselect using GPIOs.
> - *
> - * DLYBCT would add delays between words, slowing down transfers.
> - * It could potentially be useful to cope with DMA bottlenecks, but
> - * in those cases it's probably best to just use a lower bitrate.
> */
> csr |= SPI_BF(DLYBS, 0);
> - csr |= SPI_BF(DLYBCT, 0);
> +
> + /* DLYBCT adds delays between words. This is useful for slow devices
> + * that need a bit of time to setup the next transfer.
> + */
> + csr |= SPI_BF(DLYBCT,
> + (as->spi_clk / 1000000 * spi->word_delay_us) >> 5);

Looks good to me:
Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com>


> asd = spi->controller_state;
> if (!asd) {
>


--
Nicolas Ferre
\
 
 \ /
  Last update: 2019-01-30 09:16    [W:0.065 / U:5.940 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site