lkml.org 
[lkml]   [2019]   [Jan]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v5 1/2] spi: support inter-word delay requirement for devices
Hi Jonas,

On Tue, Jan 29, 2019 at 9:55 PM Jonas Bonn <jonas@norrbonn.se> wrote:
> Some devices are slow and cannot keep up with the SPI bus and therefore
> require a short delay between words of the SPI transfer.
>
> The example of this that I'm looking at is a SAMA5D2 with a minimum SPI
> clock of 400kHz talking to an AVR-based SPI slave. The AVR cannot put
> bytes on the bus fast enough to keep up with the SoC's SPI controller
> even at the lowest bus speed.
>
> This patch introduces the ability to specify a required inter-word
> delay for SPI devices. It is up to the controller driver to configure
> itself accordingly in order to introduce the requested delay.
>
> Note that, for spi_transfer, there is already a field word_delay that
> provides similar functionality. This field, however, is specified in
> clock cycles (and worse, SPI controller cycles, not SCK cycles); that
> makes this value dependent on the master clock instead of the device
> clock for which the delay is intended to provide some relief. This
> patch leaves this old word_delay in place and provides a time-based
> word_delay_us alongside it; the new field fits in the struct padding
> so struct size is constant. There is only one in-kernel user of the
> word_delay field and presumably that driver could be reworked to use
> the time-based value instead.

Thanks for your patch!

> The time-based delay is limited to 8 bits as these delays are intended
> to be short. The SAMA5D2 that I've tested this on limits delays to a
> maximum of ~100us, which is already many word-transfer periods even at
> the minimum transfer speed supported by the controller.

Still, the similar delay_usecs uses a u16.

> --- a/include/linux/spi/spi.h
> +++ b/include/linux/spi/spi.h

> @@ -803,6 +808,7 @@ struct spi_transfer {
> #define SPI_NBITS_DUAL 0x02 /* 2bits transfer */
> #define SPI_NBITS_QUAD 0x04 /* 4bits transfer */
> u8 bits_per_word;
> + u8 word_delay_us;

us for µs

> u16 delay_usecs;

usecs for µs

Can we please try to be consistent?

Gr{oetje,eeting}s,

Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds

\
 
 \ /
  Last update: 2019-01-30 08:36    [W:0.070 / U:2.508 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site