lkml.org 
[lkml]   [2019]   [Jan]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 2/2] mtd: spi-nor: cadence-quadspi: Add support for Octal SPI controller
From
Date
Hi, Tudor,

On 20/01/19 8:26 PM, Tudor.Ambarus@microchip.com wrote:
> Hi, Vignesh,
>
> On 01/16/2019 12:30 PM, Vignesh R wrote:
>> Cadence OSPI controller IP supports Octal IO (x8 IO lines),
>> It also has an integrated PHY. IP register layout is very
>> similar to existing QSPI IP except for additional bits to support Octal
>> and Octal DDR mode. Therefore, extend current driver to support Octal
>> mode.
>>
>> Signed-off-by: Vignesh R <vigneshr@ti.com>
>> ---
>> v3: No changes
>>
>> v2:
>> Declare Octal mode capability based on compatible.
>>
>> drivers/mtd/spi-nor/cadence-quadspi.c | 54 +++++++++++++++++++++------
>> 1 file changed, 42 insertions(+), 12 deletions(-)
>>
>> diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c b/drivers/mtd/spi-nor/cadence-quadspi.c
>> index 04cedd3a2bf6..31ed50f78972 100644
>> --- a/drivers/mtd/spi-nor/cadence-quadspi.c
>> +++ b/drivers/mtd/spi-nor/cadence-quadspi.c
>> @@ -93,6 +93,11 @@ struct cqspi_st {
>> struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
>> };
>>
>> +struct cqspi_driver_platdata {
>> + u32 hwcaps_mask;
>> + u8 quirks;
>> +};
>> +
>> /* Operation timeout value */
>> #define CQSPI_TIMEOUT_MS 500
>> #define CQSPI_READ_TIMEOUT_MS 10
>> @@ -101,6 +106,7 @@ struct cqspi_st {
>> #define CQSPI_INST_TYPE_SINGLE 0
>> #define CQSPI_INST_TYPE_DUAL 1
>> #define CQSPI_INST_TYPE_QUAD 2
>> +#define CQSPI_INST_TYPE_OCTAL 3
>>
>> #define CQSPI_DUMMY_CLKS_PER_BYTE 8
>> #define CQSPI_DUMMY_BYTES_MAX 4
>> @@ -911,6 +917,9 @@ static int cqspi_set_protocol(struct spi_nor *nor, const int read)
>> case SNOR_PROTO_1_1_4:
>> f_pdata->data_width = CQSPI_INST_TYPE_QUAD;
>> break;
>> + case SNOR_PROTO_1_1_8:
>> + f_pdata->data_width = CQSPI_INST_TYPE_OCTAL;
>> + break;
>> default:
>> return -EINVAL;
>> }
>> @@ -1213,21 +1222,19 @@ static void cqspi_request_mmap_dma(struct cqspi_st *cqspi)
>>
>> static int cqspi_setup_flash(struct cqspi_st *cqspi, struct device_node *np)
>> {
>> - const struct spi_nor_hwcaps hwcaps = {
>> - .mask = SNOR_HWCAPS_READ |
>> - SNOR_HWCAPS_READ_FAST |
>> - SNOR_HWCAPS_READ_1_1_2 |
>> - SNOR_HWCAPS_READ_1_1_4 |
>> - SNOR_HWCAPS_PP,
>> - };
>> struct platform_device *pdev = cqspi->pdev;
>> struct device *dev = &pdev->dev;
>> + struct cqspi_driver_platdata *ddata;
>
> const struct cqspi_driver_platdata *ddata;
>
>> + struct spi_nor_hwcaps hwcaps;
>> struct cqspi_flash_pdata *f_pdata;
>> struct spi_nor *nor;
>> struct mtd_info *mtd;
>> unsigned int cs;
>> int i, ret;
>>
>> + ddata = (struct cqspi_driver_platdata *)of_device_get_match_data(dev);
>
> You forgot to check for NULL. Also, I would expect an implicit type cast, you
> can drop the explicit cast.
>
>> + hwcaps.mask = ddata->hwcaps_mask;
>> +
>> /* Get flash device data */
>> for_each_available_child_of_node(dev->of_node, np) {
>> ret = of_property_read_u32(np, "reg", &cs);
>> @@ -1310,7 +1317,7 @@ static int cqspi_probe(struct platform_device *pdev)
>> struct cqspi_st *cqspi;
>> struct resource *res;
>> struct resource *res_ahb;
>> - unsigned long data;
>> + struct cqspi_driver_platdata *ddata;
>
> const struct cqspi_driver_platdata *ddata;
>
>> int ret;
>> int irq;
>>
>> @@ -1377,8 +1384,8 @@ static int cqspi_probe(struct platform_device *pdev)
>> }
>>
>> cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
>> - data = (unsigned long)of_device_get_match_data(dev);
>> - if (data & CQSPI_NEEDS_WR_DELAY)
>> + ddata = (struct cqspi_driver_platdata *)of_device_get_match_data(dev);
>
> I would expect an implicit type cast, you can drop the explicit cast.
>
>> + if (ddata && (ddata->quirks & CQSPI_NEEDS_WR_DELAY))
>> cqspi->wr_delay = 5 * DIV_ROUND_UP(NSEC_PER_SEC,
>> cqspi->master_ref_clk_hz);
>>
>> @@ -1460,14 +1467,37 @@ static const struct dev_pm_ops cqspi__dev_pm_ops = {
>> #define CQSPI_DEV_PM_OPS NULL
>> #endif
>>
>> +#define cqspi_base_hwcaps_mask \
>> + (SNOR_HWCAPS_READ | SNOR_HWCAPS_READ_FAST | \
>> + SNOR_HWCAPS_READ_1_1_2 | SNOR_HWCAPS_READ_1_1_4 | \
>> + SNOR_HWCAPS_PP)
>> +
>> +static const struct cqspi_driver_platdata cdns_qspi = {
>> + .hwcaps_mask = cqspi_base_hwcaps_mask,
>> +};
>> +
>> +static const struct cqspi_driver_platdata k2g_qspi = {
>> + .hwcaps_mask = cqspi_base_hwcaps_mask,
>> + .quirks = CQSPI_NEEDS_WR_DELAY,
>> +};
>> +
>> +static const struct cqspi_driver_platdata am654_ospi = {
>> + .hwcaps_mask = cqspi_base_hwcaps_mask | SNOR_HWCAPS_READ_1_1_8,
>> + .quirks = CQSPI_NEEDS_WR_DELAY,
>> +};
>> +
>> static const struct of_device_id cqspi_dt_ids[] = {
>> {
>> .compatible = "cdns,qspi-nor",
>> - .data = (void *)0,
>> + .data = (void *)&cdns_qspi,
>
> You can drop the (void *) cast.
>
> Looks good. Did you test the octal mode with mt35xu512aba? If yes, it would be
> nice to specify this in the commit message.
>

Yes, octal mode was tested with mt35xu512aba flash. I will address all
the comments in v4. Thanks for the review!


--
Regards
Vignesh

\
 
 \ /
  Last update: 2019-01-21 09:30    [W:0.050 / U:7.936 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site