Messages in this thread | | | Subject | Re: [PATCH v4 1/4] can: m_can: Create a m_can platform framework | From | Wolfgang Grandegger <> | Date | Fri, 18 Jan 2019 07:56:24 +0100 |
| |
Hello Dan,
Am 17.01.19 um 21:08 schrieb Dan Murphy: > Wolfgang > > On 1/17/19 2:05 PM, Dan Murphy wrote: >> Create a m_can platform framework that peripherial >> devices can register to and use common code and register sets. >> The peripherial devices may provide read/write and configuration >> support of the IP. >> >> Signed-off-by: Dan Murphy <dmurphy@ti.com> >> --- >> drivers/net/can/m_can/m_can.c | 6 + >> drivers/net/can/m_can/m_can_platform.c | 209 +++++++++++++++++++++++++ >> drivers/net/can/m_can/m_can_platform.h | 163 +++++++++++++++++++ >> 3 files changed, 378 insertions(+) >> create mode 100644 drivers/net/can/m_can/m_can_platform.c >> create mode 100644 drivers/net/can/m_can/m_can_platform.h >>
... snip ...
> This patch set is working for the TCAN and at least boots on io-mapped devices. > We have a couple of customers who are looking at using this implementation and we would like to > start moving this patch set along in the review. > > I did not put a change log in here as there have been no comments for the last 3 patch sets I sent. > > This v4 squashes a few bugs I found during testing across all the files.
OK, after a very busy week I will try to find time for the review... finally.
Thanks,
Wolfgang.
| |