lkml.org 
[lkml]   [2019]   [Jan]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 1/2] dt-bindings: usb: ci-hdrc-usb2: add property power-active-high
Date
The i.MX6q/dl USB controller may drive the usb power line directly, but the
polarity depends on the board. Reset state of the polarity is low-active so
add this property to allow it to be high-active.

Signed-off-by: Philipp Puschmann <philipp.puschmann@emlix.com>
---
Changes in v3: add description
---
Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 1 +
1 file changed, 1 insertion(+)

diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
index adae82385dd6..8696e3eff6e7 100644
--- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
+++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
@@ -93,6 +93,7 @@ i.mx specific properties
- over-current-active-low: over current signal polarity is active low.
- over-current-active-high: over current signal polarity is active high.
It's recommended to specify the over current polarity.
+- power-active-high: power signal polarity is high active (only for imx6q/dl)
- external-vbus-divider: enables off-chip resistor divider for Vbus

Example:
--
2.20.1
\
 
 \ /
  Last update: 2019-01-16 12:12    [W:0.082 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site