lkml.org 
[lkml]   [2019]   [Jan]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 2/6] spmi: pmic-arb: convert to v2 irq interfaces to support hierarchical IRQ chips
From
Date
Quoting Brian Masney (2019-01-11 15:00:04)
> On Fri, Jan 11, 2019 at 02:07:09PM -0800, Stephen Boyd wrote:
> > Quoting Brian Masney (2019-01-09 17:12:54)
> > > Convert the spmi-pmic-arb IRQ code to use the version 2 IRQ interface
> > > in order to support hierarchical IRQ chips. This is necessary so that
> > > spmi-gpio can be setup as a hierarchical IRQ chip with pmic-arb as the
> > > parent. IRQ chips in device tree should be usable from the start without
> > > the consumer having to make an additional call to gpio[d]_to_irq() to
> > > get the proper IRQ on the parent. Driver was tested on a LG Nexus 5
> > > (hammerhead) phone.
> > >
> > > Signed-off-by: Brian Masney <masneyb@onstation.org>
> > > ---
> > > Changes since v2:
> > > - None
> > >
> > > Changes since v1:
> > > - Add intspec variable to qpnpint_irq_domain_translate to reduce the
> > > overall diff.
> > > - Remove irq_domain_disassociate hack.
> >
> > I thought we would need to keep that around? And then dispose of the
> > hack later on. Won't this just wreck the world almost immediately
> > because the MFD is counting irqs from DT?
>
> We won't run into the issue with the MFD counting the IRQs since the
> interrupts property was removed and the interrupt-controller property
> was added to device tree in the same patch. The interrupts property that
> we ultimately don't need was the issue that I ran into with the MFD
> subsystem.
>
> However to be certain, I retested and we need the temporary hack since
> pmic_gpio_to_irq in this series uses the new SPMI IRQ controller. It
> breaks as soon as patch 4 in this series (qcom: spmi-gpio: add support
> for hierarchical IRQ chip) is applied but starts working again at patch
> 5 (ARM: dts: qcom: pm8941: add interrupt controller).
>
> I'll respin this series this weekend with the temporary hack and drop it
> later in the series. Sorry about the noise and thanks for the
> reviewed-bys.
>

Ok sounds good. Can you also fix all the spmi-gpio specifying dts files?
There are more than just two PMIC dts files that need changes (per my
grep results sent to the list earlier).

\
 
 \ /
  Last update: 2019-01-12 00:40    [W:0.035 / U:0.772 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site