lkml.org 
[lkml]   [2019]   [Jan]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 4/6] qcom: spmi-gpio: add support for hierarchical IRQ chip
From
Date
Quoting Brian Masney (2019-01-09 17:12:56)
> spmi-gpio did not have any irqchip support so consumers of this in
> device tree would need to call gpio[d]_to_irq() in order to get the
> proper IRQ on the underlying PMIC. IRQ chips in device tree should
> be usable from the start without the consumer having to make an
> additional call to get the proper IRQ on the parent. This patch adds
> hierarchical IRQ chip support to the spmi-gpio code to correct this
> issue.
>
> Driver was tested using the volume buttons (via gpio-keys) on the LG
> Nexus 5 (hammerhead) phone with the following two configurations.
>
> volume-up {
> interrupts-extended = <&pm8941_gpios 2 IRQ_TYPE_EDGE_BOTH>;
> ...
> };
>
> volume-up {
> gpios = <&pm8941_gpios 2 GPIO_ACTIVE_LOW>;
> ...
> };
>
> Both configurations now show that spmi-gpio is the IRQ domain and that
> the IRQ is setup in a hierarchy.
>
> $ grep volume_up /proc/interrupts
> 72: 6 0 spmi-gpio 1 Edge volume_up
>
> $ cat /sys/kernel/debug/irq/irqs/72
> handler: handle_edge_irq
> device: (null)
> status: 0x00000403
> _IRQ_NOPROBE
> istate: 0x00000000
> ddepth: 0
> wdepth: 0
> dstate: 0x02400203
> IRQ_TYPE_EDGE_RISING
> IRQ_TYPE_EDGE_FALLING
> IRQD_ACTIVATED
> IRQD_IRQ_STARTED
> node: 0
> affinity: 0-3
> effectiv:
> domain: :soc:spmi@fc4cf000:pm8941@0:gpios@c000
> hwirq: 0x1
> chip: spmi-gpio
> flags: 0x4
> IRQCHIP_MASK_ON_SUSPEND
> parent:
> domain: :soc:spmi@fc4cf000
> hwirq: 0xc100057
> chip: pmic_arb
> flags: 0x4
> IRQCHIP_MASK_ON_SUSPEND
>
> Signed-off-by: Brian Masney <masneyb@onstation.org>
> ---

Reviewed-by: Stephen Boyd <sboyd@kernel.org>

\
 
 \ /
  Last update: 2019-01-11 23:09    [W:0.050 / U:12.880 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site