lkml.org 
[lkml]   [2018]   [Sep]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
SubjectRe: [PATCH net 3/7] lan78xx: Check for supported Wake-on-LAN modes
From
Date
On 09/25/2018 10:32 AM, Woojung.Huh@microchip.com wrote:
> Hi Florian,
>
>>>> + if (pdata->wol == 0)
>>>> + return -EINVAL;
>>>> +
>>> It will make function return when disabling WOL.
>>
>> Huh, yes, good point.
>>
>>> Is there other place handling this scenario?
>>
>> How do you mean?
>>
> I meant there is another path I might miss when disabling WOL
> than this xxx_set_wol().

I don't think so, at least not from the ethtool perspective, this should
fix the issue before, and simplifying the code, since all we are doing
it taking a bitmask, checking each bit we support, and again, make it
the same bitmask in pdata->wol, can you test that? If you have a new
enough version of ethtool, try using: ethtool -s <iface> wol f, which
was added recently and which this driver does not support:

diff --git a/drivers/net/usb/lan78xx.c b/drivers/net/usb/lan78xx.c
index a9991c5f4736..2e37028ef6ca 100644
--- a/drivers/net/usb/lan78xx.c
+++ b/drivers/net/usb/lan78xx.c
@@ -1401,19 +1401,10 @@ static int lan78xx_set_wol(struct net_device
*netdev,
if (ret < 0)
return ret;

- pdata->wol = 0;
- if (wol->wolopts & WAKE_UCAST)
- pdata->wol |= WAKE_UCAST;
- if (wol->wolopts & WAKE_MCAST)
- pdata->wol |= WAKE_MCAST;
- if (wol->wolopts & WAKE_BCAST)
- pdata->wol |= WAKE_BCAST;
- if (wol->wolopts & WAKE_MAGIC)
- pdata->wol |= WAKE_MAGIC;
- if (wol->wolopts & WAKE_PHY)
- pdata->wol |= WAKE_PHY;
- if (wol->wolopts & WAKE_ARP)
- pdata->wol |= WAKE_ARP;
+ if (pdata->wol & ~WAKE_ALL)
+ return -EINVAL;
+
+ pdata->wol = wol->wolopts;

device_set_wakeup_enable(&dev->udev->dev, (bool)wol->wolopts);

--
Florian

\
 
 \ /
  Last update: 2018-09-25 20:36    [W:0.074 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site