lkml.org 
[lkml]   [2018]   [Sep]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] efi/libstub/arm: default EFI_ARMSTUB_DTB_LOADER to y
Date
Default EFI_ARMSTUB_DTB_LOADER to y to allow the dtb= command
line parameter to function with efi loader.

Required for development purposes and to boot on existing bootloaders
that do not support devicetree provided by the platform or by the bootloader.

Fixes: 3d7ee348aa41 ("efi/libstub/arm: Add opt-in Kconfig option for the DTB loader")
Signed-off-by: Scott Branden <scott.branden@broadcom.com>
---
drivers/firmware/efi/Kconfig | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/firmware/efi/Kconfig b/drivers/firmware/efi/Kconfig
index d8e159f..0a84d01 100644
--- a/drivers/firmware/efi/Kconfig
+++ b/drivers/firmware/efi/Kconfig
@@ -90,14 +90,17 @@ config EFI_ARMSTUB
config EFI_ARMSTUB_DTB_LOADER
bool "Enable the DTB loader"
depends on EFI_ARMSTUB
+ default y
help
Select this config option to add support for the dtb= command
line parameter, allowing a device tree blob to be loaded into
memory from the EFI System Partition by the stub.

- The device tree is typically provided by the platform or by
- the bootloader, so this option is mostly for development
- purposes only.
+ If the device tree is provided by the platform or by
+ the bootloader this option may not be needed.
+ But, for various development reasons and to maintain existing
+ functionality for bootloaders that do not have such support
+ this option is necessary.

config EFI_BOOTLOADER_CONTROL
tristate "EFI Bootloader Control"
--
2.5.0
\
 
 \ /
  Last update: 2018-09-11 22:27    [W:0.033 / U:2.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site