lkml.org 
[lkml]   [2018]   [Aug]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH RESEND RFC 1/4] drivers: pinctrl: qcom: add wakeup capability to GPIO
Date
Quoting Marc Zyngier (2018-08-07 23:26:32)
> On Tue, 07 Aug 2018 23:05:07 -0700
> Stephen Boyd <swboyd@chromium.org> wrote:
>
> > Quoting Lina Iyer (2018-08-02 05:58:27)
> > > On Thu, Aug 02 2018 at 01:27 -0600, Marc Zyngier wrote:
> > > >
> > > >Sure. But once woken up (GIC *and* TLMM), the gpio line (which I
> > > >assume is level) is still high at the TLMM input. So why isn't it
> > > >registering that state once it has been woken up?
> > > >
> > > >I can understand that it would be missing an edge. But that doesn't
> > > >hold for level signalling.
> > > >
> > > Sure, yes. Sorry for not registering your point in my response.
> > > Once woken up we should see the level interrupt in TLMM.
> >
> > And the level type gpio interrupt will trigger the TLMM summary
> > interrupt line after the wakeup? So then the only thing that needs to be
> > replayed is edge interrupts? How are edge interrupts going to be
> > replayed?
>
> Level interrupts should be taken care of without doing anything, by the
> very nature of being a level signal.

Right. I suspect we'll still need to configure the PDC to actually wake
up on the level triggered signal though so PDC needs to be told to
unmask the line.

>
> Edge interrupts should be replayed using check_irq_resend() after
> taking the right locks and making the interrupt pending. Or, if there
> is a way for SW to make the interrupt pending at the TLMM level, to use
> that as a way to reinject the interrupt (which would be the preferred
> way, as it avoids all kind of ugly locking considerations).
>

Ok. Looking at the hardware it seems that I can write the interrupt
status bit directly for an edge type interrupt and that causes the
interrupt handler to run. So that's good news, we can use that ability
to directly inject interrupts here.

\
 
 \ /
  Last update: 2018-08-09 19:31    [W:0.097 / U:4.496 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site