Messages in this thread | | | From | Jernej Skrabec <> | Subject | [PATCH 0/5] Set max rate for video PLLs | Date | Thu, 9 Aug 2018 18:52:12 +0200 |
| |
This patch series implement maximum rate constraint for video PLLs, because it is possible to set higher PLL rate that is actually supported in HW.
Issue became apparent when user reported non-working monitor connected to board with H5 SoC. Native monitor resolution in this case was 2560x1080, with 185580 kHz pixel clock. Clock subsystem found out that best matching pixel clock can be generated if video PLL is set to 2040 MHz, which is way out of specs for PLL. With this patch series applied, everything worked just fine, with slightly higher rate error, but within working limits for PLL and HDMI.
I'm not sure if "Fixes" tag should be added. It solves real world problem, but there was nothing wrongly implemented, just upper limit is missing.
While user reported that these patches solve the issue on H5, I added similar fixes for other SoCs too. Since I don't have such monitor, I only tested if board boots up and if HDMI works (H3, R40 and A83T).
Jernej Skrabec (5): clk: sunxi-ng: Add maximum rate constraint to NM PLLs clk: sunxi-ng: h3/h5: Add max. rate constraint to pll-video clk: sunxi-ng: r40: Add max. rate constraint to video PLLs clk: sunxi-ng: nkmp: Add constraint for maximum rate clk: sunxi-ng: a83t: Add max. rate constraint to video PLLs
drivers/clk/sunxi-ng/ccu-sun8i-a83t.c | 2 ++ drivers/clk/sunxi-ng/ccu-sun8i-h3.c | 25 ++++++------- drivers/clk/sunxi-ng/ccu-sun8i-r40.c | 52 +++++++++++++-------------- drivers/clk/sunxi-ng/ccu_nkmp.c | 7 ++++ drivers/clk/sunxi-ng/ccu_nkmp.h | 1 + drivers/clk/sunxi-ng/ccu_nm.c | 7 ++++ drivers/clk/sunxi-ng/ccu_nm.h | 30 ++++++++++++++++ 7 files changed, 86 insertions(+), 38 deletions(-)
-- 2.18.0
| |