lkml.org 
[lkml]   [2018]   [Aug]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v1 07/10] thermal: tsens: Check if the IP is correctly enabled by firmware
Date
The SROT registers are initialised by the secure firmware at boot. We
don't have write access to the registers. Check if the block is enabled
before continuing.

Signed-off-by: Amit Kucheria <amit.kucheria@linaro.org>
---
drivers/thermal/qcom/tsens-common.c | 17 +++++++++++++++++
1 file changed, 17 insertions(+)

diff --git a/drivers/thermal/qcom/tsens-common.c b/drivers/thermal/qcom/tsens-common.c
index 0b8a793f15f4..d250b757d1f0 100644
--- a/drivers/thermal/qcom/tsens-common.c
+++ b/drivers/thermal/qcom/tsens-common.c
@@ -12,6 +12,11 @@
#include <linux/regmap.h>
#include "tsens.h"

+/* SROT */
+#define CTRL_OFFSET 0x4
+#define TSENS_EN BIT(0)
+
+/* TM */
#define STATUS_OFFSET 0x30
#define SN_ADDR_OFFSET 0x4
#define SN_ST_TEMP_MASK 0x3ff
@@ -119,6 +124,8 @@ int __init init_common(struct tsens_device *tmdev)
{
void __iomem *tm_base, *srot_base;
struct resource *res;
+ u32 code;
+ int ret;
struct platform_device *op = of_find_device_by_node(tmdev->dev->of_node);

if (!op)
@@ -151,5 +158,15 @@ int __init init_common(struct tsens_device *tmdev)
if (IS_ERR(tmdev->tm_map))
return PTR_ERR(tmdev->tm_map);

+ if (tmdev->srot_map) {
+ ret = regmap_read(tmdev->srot_map, CTRL_OFFSET, &code);
+ if (ret)
+ return ret;
+ if (!(code & TSENS_EN)) {
+ dev_err(tmdev->dev, "tsens device is not enabled\n");
+ return -ENODEV;
+ }
+ }
+
return 0;
}
--
2.17.1
\
 
 \ /
  Last update: 2018-08-09 14:33    [W:0.066 / U:55.388 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site