Messages in this thread Patch in this message | | | From | Simon Goldschmidt <> | Subject | [PATCH] spi: dw: support 4-16 bits per word | Date | Wed, 8 Aug 2018 09:14:21 +0200 |
| |
The spi-dw driver currently only supports 8 or 16 bits per word.
Since the hardware supports 4-16 bits per word, adapt the driver to also support this.
Tested on socfpga cyclone5 with a 9-bit SPI display.
Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com> --- drivers/spi/spi-dw.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/spi/spi-dw.c b/drivers/spi/spi-dw.c index f693bfe95ab9..2ecbb6b19cea 100644 --- a/drivers/spi/spi-dw.c +++ b/drivers/spi/spi-dw.c @@ -307,14 +307,14 @@ static int dw_spi_transfer_one(struct spi_controller *master, dws->current_freq = transfer->speed_hz; spi_set_clk(dws, chip->clk_div); } - if (transfer->bits_per_word == 8) { + if ((transfer->bits_per_word < 4) || (transfer->bits_per_word > 16)) + return -EINVAL; + if (transfer->bits_per_word <= 8) { dws->n_bytes = 1; dws->dma_width = 1; - } else if (transfer->bits_per_word == 16) { + } else { dws->n_bytes = 2; dws->dma_width = 2; - } else { - return -EINVAL; } /* Default SPI mode is SCPOL = 0, SCPH = 0 */ cr0 = (transfer->bits_per_word - 1) @@ -493,7 +493,7 @@ int dw_spi_add_host(struct device *dev, struct dw_spi *dws) } master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_LOOP; - master->bits_per_word_mask = SPI_BPW_MASK(8) | SPI_BPW_MASK(16); + master->bits_per_word_mask = SPI_BPW_RANGE_MASK(4, 16); master->bus_num = dws->bus_num; master->num_chipselect = dws->num_cs; master->setup = dw_spi_setup; -- 2.17.1
| |