lkml.org 
[lkml]   [2018]   [Aug]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2] pinctrl/amd: use byte access to clear irq/wake status bits
Date
Commit 6afb10267c1692 ("pinctrl/amd: fix masking of GPIO interrupts")
changed to the clearing of interrupt status bits to a RMW in a critical
section. This works, but is a bit overkill.

The relevant interrupt/wake status bits are in the Most Significant Byte
of a 32-bit word. These two are the only write-able bits in this byte.

Therefore, it should be safe to just write these bits back as a byte
access without any additional locking.

Signed-off-by: Daniel Kurtz <djkurtz@chromium.org>
---
drivers/pinctrl/pinctrl-amd.c | 11 +++++------
1 file changed, 5 insertions(+), 6 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-amd.c b/drivers/pinctrl/pinctrl-amd.c
index 41ccc759b8b886..7698bd9f6b687c 100644
--- a/drivers/pinctrl/pinctrl-amd.c
+++ b/drivers/pinctrl/pinctrl-amd.c
@@ -558,15 +558,14 @@ static irqreturn_t amd_gpio_irq_handler(int irq, void *dev_id)
irq = irq_find_mapping(gc->irq.domain, irqnr + i);
generic_handle_irq(irq);

- /* Clear interrupt.
- * We must read the pin register again, in case the
+ /*
+ * Write 1 to clear the irq/wake status bits in MSByte.
+ * All other bits in this byte are read-only. This
+ * avoids modifying the lower 24-bits, in case their
* value was changed while executing
* generic_handle_irq() above.
*/
- raw_spin_lock_irqsave(&gpio_dev->lock, flags);
- regval = readl(regs + i);
- writel(regval, regs + i);
- raw_spin_unlock_irqrestore(&gpio_dev->lock, flags);
+ writeb((regval >> 24), (u8 *)(regs + i) + 3);
ret = IRQ_HANDLED;
}
}
--
2.18.0.1017.ga543ac7ca45-goog
\
 
 \ /
  Last update: 2018-08-22 18:58    [W:0.028 / U:1.348 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site