lkml.org 
[lkml]   [2018]   [Aug]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] gpio: 74x164: add lines-initial-states property
Date
This adds the ability to define the initial state of each output line on
device probe.

Signed-off-by: David Bauer <mail@david-bauer.net>
---
Documentation/devicetree/bindings/gpio/gpio-74x164.txt | 5 +++++
drivers/gpio/gpio-74x164.c | 3 +++
2 files changed, 8 insertions(+)

diff --git a/Documentation/devicetree/bindings/gpio/gpio-74x164.txt b/Documentation/devicetree/bindings/gpio/gpio-74x164.txt
index 2a97553d8d76..580b18065ad3 100644
--- a/Documentation/devicetree/bindings/gpio/gpio-74x164.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-74x164.txt
@@ -14,6 +14,11 @@ Required properties:

Optional properties:
- enable-gpios: GPIO connected to the OE (Output Enable) pin.
+- lines-initial-states: Bitmask that specifies the initial state of
+ each line. When a bit is set to zero, the corresponding output line
+ is initialized LOW. When a bit is set to one, the corresponding
+ output line is initialized HIGH. In case this property is not
+ defined, all lines will be initialized as LOW.

Example:

diff --git a/drivers/gpio/gpio-74x164.c b/drivers/gpio/gpio-74x164.c
index fb7b620763a2..275310a0a538 100644
--- a/drivers/gpio/gpio-74x164.c
+++ b/drivers/gpio/gpio-74x164.c
@@ -150,6 +150,9 @@ static int gen_74x164_probe(struct spi_device *spi)
chip->gpio_chip.parent = &spi->dev;
chip->gpio_chip.owner = THIS_MODULE;

+ of_property_read_u8_array(spi->dev.of_node, "lines-initial-states",
+ chip->buffer, chip->registers);
+
mutex_init(&chip->lock);

ret = __gen_74x164_write_config(chip);
--
2.18.0
\
 
 \ /
  Last update: 2018-08-15 22:25    [W:0.059 / U:1.512 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site