lkml.org 
[lkml]   [2018]   [Aug]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] media: i2c: lm3560: use conservative defaults
From
Date
Hi Pavel,

I think if there is not exist pdata, it should be set to the value of power on reset (POR) to sync with the chip.

According to the LM3560 datasheet, Flash Timeout is 512ms, Flash current is 875mA and Torch Current is 93.75mA.

Daniel Jeong.

On 07/016/2018 18:08 PM, Pavel Machek wrote:

> If no pdata is found, we should use lowest current settings, not highest.
>
> Signed-off-by: Pavel Machek <pavel@ucw.cz>
>
> ---
>
> v2: I got notification from patchwork that patch no longer applies, so
> I'm rediffing the patch.
>
> diff --git a/drivers/media/i2c/lm3560.c b/drivers/media/i2c/lm3560.c
> index b600e03a..c4e5ed5 100644
> --- a/drivers/media/i2c/lm3560.c
> +++ b/drivers/media/i2c/lm3560.c
> @@ -420,14 +434,14 @@ static int lm3560_probe(struct i2c_client *client,
> pdata = devm_kzalloc(&client->dev, sizeof(*pdata), GFP_KERNEL);
> if (pdata == NULL)
> return -ENODEV;
> - pdata->peak = LM3560_PEAK_3600mA;
> - pdata->max_flash_timeout = LM3560_FLASH_TOUT_MAX;
> + pdata->peak = LM3560_PEAK_1600mA;
> + pdata->max_flash_timeout = LM3560_FLASH_TOUT_MIN;
> /* led 1 */
> - pdata->max_flash_brt[LM3560_LED0] = LM3560_FLASH_BRT_MAX;
> - pdata->max_torch_brt[LM3560_LED0] = LM3560_TORCH_BRT_MAX;
> + pdata->max_flash_brt[LM3560_LED0] = LM3560_FLASH_BRT_MIN;
> + pdata->max_torch_brt[LM3560_LED0] = LM3560_TORCH_BRT_MIN;
> /* led 2 */
> - pdata->max_flash_brt[LM3560_LED1] = LM3560_FLASH_BRT_MAX;
> - pdata->max_torch_brt[LM3560_LED1] = LM3560_TORCH_BRT_MAX;
> + pdata->max_flash_brt[LM3560_LED1] = LM3560_FLASH_BRT_MIN;
> + pdata->max_torch_brt[LM3560_LED1] = LM3560_TORCH_BRT_MIN;
> }
> flash->pdata = pdata;
> flash->dev = &client->dev;
>
>
>

\
 
 \ /
  Last update: 2018-08-11 08:11    [W:0.050 / U:2.032 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site