lkml.org 
[lkml]   [2018]   [Jul]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 10/34] media: camss: csid: Configure data type and decode format properly
Date
The CSID decodes the input data stream. When the input comes from
the Test Generator the format of the stream is set on the source
media pad. When the input comes from the CSIPHY the format is the
one on the sink media pad. Use the proper format for each case.

Signed-off-by: Todor Tomov <todor.tomov@linaro.org>
---
drivers/media/platform/qcom/camss/camss-csid.c | 16 +++++++++++-----
1 file changed, 11 insertions(+), 5 deletions(-)

diff --git a/drivers/media/platform/qcom/camss/camss-csid.c b/drivers/media/platform/qcom/camss/camss-csid.c
index c0fef17..3cde07e 100644
--- a/drivers/media/platform/qcom/camss/camss-csid.c
+++ b/drivers/media/platform/qcom/camss/camss-csid.c
@@ -384,9 +384,6 @@ static int csid_set_stream(struct v4l2_subdev *sd, int enable)
!media_entity_remote_pad(&csid->pads[MSM_CSID_PAD_SINK]))
return -ENOLINK;

- dt = csid_get_fmt_entry(csid->fmt[MSM_CSID_PAD_SRC].code)->
- data_type;
-
if (tg->enabled) {
/* Config Test Generator */
struct v4l2_mbus_framefmt *f =
@@ -408,6 +405,9 @@ static int csid_set_stream(struct v4l2_subdev *sd, int enable)
writel_relaxed(val, csid->base +
CAMSS_CSID_TG_DT_n_CGG_0(0));

+ dt = csid_get_fmt_entry(
+ csid->fmt[MSM_CSID_PAD_SRC].code)->data_type;
+
/* 5:0 data type */
val = dt;
writel_relaxed(val, csid->base +
@@ -417,6 +417,9 @@ static int csid_set_stream(struct v4l2_subdev *sd, int enable)
val = tg->payload_mode;
writel_relaxed(val, csid->base +
CAMSS_CSID_TG_DT_n_CGG_2(0));
+
+ df = csid_get_fmt_entry(
+ csid->fmt[MSM_CSID_PAD_SRC].code)->decode_format;
} else {
struct csid_phy_config *phy = &csid->phy;

@@ -431,13 +434,16 @@ static int csid_set_stream(struct v4l2_subdev *sd, int enable)

writel_relaxed(val,
csid->base + CAMSS_CSID_CORE_CTRL_1);
+
+ dt = csid_get_fmt_entry(
+ csid->fmt[MSM_CSID_PAD_SINK].code)->data_type;
+ df = csid_get_fmt_entry(
+ csid->fmt[MSM_CSID_PAD_SINK].code)->decode_format;
}

/* Config LUT */

dt_shift = (cid % 4) * 8;
- df = csid_get_fmt_entry(csid->fmt[MSM_CSID_PAD_SINK].code)->
- decode_format;

val = readl_relaxed(csid->base + CAMSS_CSID_CID_LUT_VC_n(vc));
val &= ~(0xff << dt_shift);
--
2.7.4
\
 
 \ /
  Last update: 2018-07-05 15:41    [W:0.201 / U:0.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site