Messages in this thread | | | From | Linus Walleij <> | Date | Sun, 29 Jul 2018 22:11:36 +0200 | Subject | Re: [PATCH 2/2] pinctrl: stm32: check node status before new gpio bank registering |
| |
On Mon, Jul 16, 2018 at 2:57 PM Alexandre Torgue <alexandre.torgue@st.com> wrote:
> Register a new GPIO bank only if GPIO bank node is enabled. This patch also > adds checks on ranges which are defined only if a bank is registered. > > Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>
Patch applied.
Alexandre can you check the discussion we've had about using GPIOLIB_IRQCHIP for multi-bank GPIOs with several IRQ lines as per drivers/gpio/gpio-tegra186.c?
Is this approach applicable for STM32 so we can pull more stuff in under GPIOLIB_IRQCHIP?
Yours, Linus Walleij
| |