lkml.org 
[lkml]   [2018]   [Jul]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/2] dt-bindings: media: i2c: Document MT9V111 bindings
Hi Jacopo,

On Mon, Jun 11, 2018 at 05:17:32PM +0200, Jacopo Mondi wrote:
> Add documentation for Aptina MT9V111 image sensor.
>
> Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
> ---
> .../bindings/media/i2c/aptina,mt9v111.txt | 46 ++++++++++++++++++++++
> 1 file changed, 46 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
>
> diff --git a/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt b/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
> new file mode 100644
> index 0000000..bac4bf0
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
> @@ -0,0 +1,46 @@
> +* Aptina MT9V111 CMOS sensor
> +----------------------------
> +
> +The Aptina MT9V111 is a 1/4-Inch VGA-format digital image sensor with a core
> +based on Aptina MT9V011 sensor and an integrated Image Flow Processor (IFP).
> +
> +The sensor has an active pixel array of 649x489 pixels and can output a number

640x480 ?

> +of image resolution and formats controllable through a simple two-wires
> +interface.
> +
> +Required properties:
> +--------------------
> +
> +- compatible: shall be "aptina,mt9v111".
> +- clocks: reference to the system clock input provider.
> +
> +Optional properties:
> +--------------------
> +
> +- enable-gpios: output enable signal, pin name "OE#". Active low.
> +- standby-gpios: low power state control signal, pin name "STANDBY".
> + Active high.
> +- reset-gpios: chip reset signal, pin name "RESET#". Active low.
> +
> +The device node must contain one 'port' child node with one 'endpoint' child
> +sub-node for its digital output video port, in accordance with the video
> +interface bindings defined in:
> +Documentation/devicetree/bindings/media/video-interfaces.txt
> +
> +Example:
> +--------
> +
> + &i2c1 {
> + camera@48 {
> + compatible = "aptina,mt9v111";
> + reg = <0x48>;
> +
> + clocks = <&camera_clk>;
> +
> + port {
> + mt9v111_out: endpoint {
> + remote-endpoint = <&ceu_in>;
> + };
> + };
> + };
> + };

--
Sakari Ailus
e-mail: sakari.ailus@iki.fi

\
 
 \ /
  Last update: 2018-07-23 16:30    [W:0.112 / U:0.248 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site