[lkml]   [2018]   [Jun]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v3 0/6] Add MCAN Support for dra76x
The following patches add dts and sysconfig support
for MCAN on TI's dra76 SOCs

The patches depend on the following series:

Changes in v3:
1. Added reset functionality to the ti-sysc
driver. This enables me to drop the hwmod
data patch as everything is being done in dt.

2. Dropped ti,hwmods from the dts nodes

3. Fixed the unit address of target-module
and mcan

4. Removed the status="disabled" in dtsi
followed by status="okay" in dts.

Changes in v2:
1. Added Support for mcan in the ti-sysc driver
Also added the target-module node for the same

2. Added clkctrl data for mcan clocks

Faiz Abbas (4):
clk: ti: dra7: Add clkctrl clock data for the mcan clocks
bus: ti-sysc: Add support for using ti-sysc for MCAN on dra76x
bus: ti-sysc: Add support for software reset
ARM: dts: Add generic interconnect target module node for MCAN

Franklin S Cooper Jr (1):
ARM: dts: dra76x: Add MCAN node

Lokesh Vutla (1):
ARM: dts: dra762: Add MCAN clock support

.../devicetree/bindings/bus/ti-sysc.txt | 1 +
arch/arm/boot/dts/dra76-evm.dts | 6 ++
arch/arm/boot/dts/dra76x.dtsi | 65 +++++++++++++++++++
drivers/bus/ti-sysc.c | 58 +++++++++++++++++
drivers/clk/ti/clk-7xx.c | 1 +
include/dt-bindings/bus/ti-sysc.h | 2 +
include/dt-bindings/clock/dra7.h | 1 +
include/linux/platform_data/ti-sysc.h | 1 +
8 files changed, 135 insertions(+)


 \ /
  Last update: 2018-06-06 08:10    [W:0.076 / U:6.164 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site