lkml.org 
[lkml]   [2018]   [Jun]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 2/2] clocksource/drivers/mtk_systimer: Add support for Mediatek SoCs
From
Date
On 27/06/2018 09:53, Stanley Chu wrote:
> This patch adds a new clock event for the timer
> found on the Mediatek SoCs.
>
> The Mediatek System Timer has several 32-bit timers.
> Only one timer is used by this driver as a clock event
> supporting oneshot events.
>
> The System Timer can be run with two clocks. A 13 MHz system
> clock and the RTC clock running at 32 KHz. This implementation
> uses the system clock with no clock source divider.
> The interrupts are shared between the different timers.
> We just enable one interrupt for the clock event. The clock
> event timer is used by all cores.
>
> Signed-off-by: Stanley Chu <stanley.chu@mediatek.com>
> ---
> drivers/clocksource/Kconfig | 13 +++-
> drivers/clocksource/Makefile | 1 +
> drivers/clocksource/mtk_systimer.c | 132 ++++++++++++++++++++++++++++++++++++

Please merge mtk_systimer.c and mtk_timer.c into a single file:

timer-mediatek.c

Patch 1:

git mv mtk_timer.c timer-mediatek.c
Change the name in Makefile

Patch 2:

Change function prefix name to _gpt_

Patch 2.1 [optional but recommended] :

Move the gpt's init code to timer-of

Patch 3:

Add code for syst in timer-mediatek.c



A couple of comments below.

> 3 files changed, 144 insertions(+), 2 deletions(-)
> create mode 100644 drivers/clocksource/mtk_systimer.c
>
> diff --git a/drivers/clocksource/Kconfig b/drivers/clocksource/Kconfig
> index dec0dd8..362c110 100644
> --- a/drivers/clocksource/Kconfig
> +++ b/drivers/clocksource/Kconfig
> @@ -442,12 +442,21 @@ config SYS_SUPPORTS_SH_CMT
> bool
>
> config MTK_TIMER
> - bool "Mediatek timer driver" if COMPILE_TEST
> + bool "Mediatek general purpose timer driver" if COMPILE_TEST
> depends on HAS_IOMEM
> select TIMER_OF
> select CLKSRC_MMIO
> help
> - Support for Mediatek timer driver.
> + Support for Mediatek General Purpose Timer (GPT) driver.
> +
> +config MTK_TIMER_SYSTIMER
> + bool "Mediatek system timer driver" if COMPILE_TEST
> + depends on HAS_IOMEM
> + select TIMER_OF
> + select CLKSRC_MMIO
> + help
> + Support for Mediatek System Timer (sys_timer) driver used as
> + a clock event supporting oneshot events.
>
> config SPRD_TIMER
> bool "Spreadtrum timer driver" if EXPERT
> diff --git a/drivers/clocksource/Makefile b/drivers/clocksource/Makefile
> index 00caf37..cdd34b2 100644
> --- a/drivers/clocksource/Makefile
> +++ b/drivers/clocksource/Makefile
> @@ -50,6 +50,7 @@ obj-$(CONFIG_FSL_FTM_TIMER) += fsl_ftm_timer.o
> obj-$(CONFIG_VF_PIT_TIMER) += vf_pit_timer.o
> obj-$(CONFIG_CLKSRC_QCOM) += qcom-timer.o
> obj-$(CONFIG_MTK_TIMER) += mtk_timer.o
> +obj-$(CONFIG_MTK_TIMER_SYSTIMER) += mtk_systimer.o
> obj-$(CONFIG_CLKSRC_PISTACHIO) += time-pistachio.o
> obj-$(CONFIG_CLKSRC_TI_32K) += timer-ti-32k.o
> obj-$(CONFIG_CLKSRC_NPS) += timer-nps.o
> diff --git a/drivers/clocksource/mtk_systimer.c b/drivers/clocksource/mtk_systimer.c
> new file mode 100644
> index 0000000..77161bb
> --- /dev/null
> +++ b/drivers/clocksource/mtk_systimer.c
> @@ -0,0 +1,132 @@
> +// SPDX-License-Identifier: GPL-2.0+
> +//
> +// Copyright (C) 2018 MediaTek Inc.
> +
> +#include <linux/interrupt.h>
> +#include <linux/irqreturn.h>
> +#include <linux/clockchips.h>
> +#include <linux/clocksource.h>
> +#include <linux/io.h>
> +#include "timer-of.h"
> +
> +/* registers */
> +#define STMR_CON (0x0)
> +#define STMR_VAL (0x4)
> +
> +#define TIMER_REG_CON(to) (timer_of_base(to) + STMR_CON)
> +#define TIMER_REG_VAL(to) (timer_of_base(to) + STMR_VAL)
> +
> +/* STMR_CON */
> +#define STMR_CON_EN BIT(0)
> +#define STMR_CON_IRQ_EN BIT(1)
> +#define STMR_CON_IRQ_CLR BIT(4)
> +
> +#define TIMER_SYNC_TICKS 3
> +
> +static void mtk_stmr_reset(struct timer_of *to)
> +{
> + /* Clear IRQ */
> + writel(STMR_CON_IRQ_CLR | STMR_CON_EN, TIMER_REG_CON(to));
> +
> + /* Reset counter */
> + writel(0, TIMER_REG_VAL(to));
> +
> + /* Disable timer */
> + writel(0, TIMER_REG_CON(to));

Wouldn't make sense to clear the interrupt after disabling the timer ?

> +}
> +
> +static void mtk_stmr_ack_irq(struct timer_of *to)
> +{
> + mtk_stmr_reset(to);
> +}
> +
> +static irqreturn_t mtk_stmr_handler(int irq, void *dev_id)
> +{
> + struct clock_event_device *clkevt = (struct clock_event_device *)dev_id;
> + struct timer_of *to = to_timer_of(clkevt);
> +
> + mtk_stmr_ack_irq(to);
> + clkevt->event_handler(clkevt);
> +
> + return IRQ_HANDLED;
> +}
> +
> +static int mtk_stmr_clkevt_next_event(unsigned long ticks,
> + struct clock_event_device *clkevt)
> +{
> + struct timer_of *to = to_timer_of(clkevt);
> +
> + /*
> + * reset timer first because we do not expect interrupt is triggered
> + * by old compare value.
> + */
> + mtk_stmr_reset(to);
> +
> + writel(STMR_CON_EN, TIMER_REG_CON(to));
> +
> + writel(ticks, TIMER_REG_VAL(to));
> +
> + writel(STMR_CON_EN | STMR_CON_IRQ_EN, TIMER_REG_CON(to));
> +
> + return 0;
> +}
> +
> +static int mtk_stmr_clkevt_shutdown(struct clock_event_device *clkevt)
> +{
> + mtk_stmr_reset(to_timer_of(clkevt));
> +
> + return 0;
> +}
> +
> +static int mtk_stmr_clkevt_resume(struct clock_event_device *clkevt)
> +{
> + return mtk_stmr_clkevt_shutdown(clkevt);
> +}
> +
> +static int mtk_stmr_clkevt_oneshot(struct clock_event_device *clkevt)
> +{
> + return 0;
> +}
> +
> +static struct timer_of to = {
> + .flags = TIMER_OF_IRQ | TIMER_OF_BASE | TIMER_OF_CLOCK,
> +
> + .clkevt = {
> + .name = "mtk-clkevt",
> + .rating = 300,
> + .features = CLOCK_EVT_FEAT_DYNIRQ | CLOCK_EVT_FEAT_ONESHOT,
> + .set_state_shutdown = mtk_stmr_clkevt_shutdown,
> + .set_state_oneshot = mtk_stmr_clkevt_oneshot,
> + .tick_resume = mtk_stmr_clkevt_resume,
> + .set_next_event = mtk_stmr_clkevt_next_event,
> + .cpumask = cpu_possible_mask,
> + },
> +
> + .of_irq = {
> + .handler = mtk_stmr_handler,
> + .flags = IRQF_TIMER | IRQF_IRQPOLL | IRQF_TRIGGER_HIGH |

Why do you need IRQF_TRIGGER_HIGH ?

> + IRQF_PERCPU,

Why IRQF_PERCPU ?

> + },
> +};
> +
> +static int __init mtk_stmr_init(struct device_node *node)
> +{
> + int ret;
> +
> + ret = timer_of_init(node, &to);
> + if (ret)
> + return ret;
> +
> + mtk_stmr_reset(&to);
> +
> + clockevents_config_and_register(&to.clkevt, timer_of_rate(&to),
> + TIMER_SYNC_TICKS, 0xffffffff);
> +
> + pr_info("mtk_stmr: irq=%d, rate=%lu, max_ns: %llu, min_ns: %llu\n",
> + timer_of_irq(&to), timer_of_rate(&to),
> + to.clkevt.max_delta_ns, to.clkevt.min_delta_ns);
> +
> + return ret;
> +}
> +
> +TIMER_OF_DECLARE(mtk_systimer, "mediatek,sys_timer", mtk_stmr_init);

No "mediatek,sys_timer" but eg. "mediatek,mt6765", so it is consistent
with the DT binding.


--
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog

\
 
 \ /
  Last update: 2018-06-27 12:01    [W:0.081 / U:0.300 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site