lkml.org 
[lkml]   [2018]   [Jun]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Subject[PATCH 2/3] dt-bindings: interrupt-controller: RISC-V local interrupt controller docs
Date
From
From: Palmer Dabbelt <palmer@dabbelt.com>

This patch adds documentation on the RISC-V local interrupt controller,
which is a per-hart interrupt controller that manages all interrupts
entering a RISC-V hart. This interrupt controller is present on all
RISC-V systems.

Signed-off-by: Palmer Dabbelt <palmer@dabbelt.com>
---
.../interrupt-controller/riscv,cpu-intc.txt | 41 ++++++++++++++++++++++
1 file changed, 41 insertions(+)
create mode 100644 Documentation/devicetree/bindings/interrupt-controller/riscv,cpu-intc.txt

diff --git a/Documentation/devicetree/bindings/interrupt-controller/riscv,cpu-intc.txt b/Documentation/devicetree/bindings/interrupt-controller/riscv,cpu-intc.txt
new file mode 100644
index 000000000000..61900e2e3868
--- /dev/null
+++ b/Documentation/devicetree/bindings/interrupt-controller/riscv,cpu-intc.txt
@@ -0,0 +1,41 @@
+RISC-V Hart-Level Interrupt Controller (HLIC)
+---------------------------------------------
+
+RISC-V cores include Control Status Registers (CSRs) which are local to each
+hart and can be read or written by software. Some of these CSRs are used to
+control local interrupts connected to the core. Every interrupt is ultimately
+routed through a hart's HLIC before it interrupts that hart.
+
+The RISC-V supervisor ISA manual specifies three interrupt sources that are
+attached to every HLIC: software interrupts, the timer interrupt, and external
+interrupts. Software interrupts are used to send IPIs between cores. The
+timer interrupt comes from an architecturally mandated real-time timer that is
+controller via SBI calls and CSR reads. External interrupts connect all other
+device interrupts to the HLIC, which are routed via the platform-level
+interrupt controller (PLIC).
+
+All RISC-V systems that conform to the supervisor ISA specification are
+required to have a HLIC with these three interrupt sources present. Since the
+interrupt map is defined by the ISA it's not listed in the HLIC's device tree
+entry, though external interrupt controllers (like the PLIC, for example) will
+need to define how their interrupts map to the relevant HLICs.
+
+Required properties:
+- compatible : "riscv,cpu-intc"
+- #interrupt-cells : should be <1>
+- interrupt-controller : Identifies the node as an interrupt controller
+
+Furthermore, this interrupt-controller MUST be embedded inside the cpu
+definition of the hart whose CSRs control these local interrupts.
+
+An example device tree entry for a HLIC is show below.
+
+ cpu1: cpu@1 {
+ compatible = "riscv";
+ ...
+ cpu1-intc: interrupt-controller {
+ #interrupt-cells = <1>;
+ compatible = "riscv,cpu-intc";
+ interrupt-controller;
+ };
+ };
--
2.16.4
\
 
 \ /
  Last update: 2018-06-23 01:22    [W:0.109 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site