Messages in this thread | | | Subject | Re: [PATCH v11 00/27] ARM: davinci: convert to common clo ck framework | From | David Lechner <> | Date | Sun, 17 Jun 2018 10:48:47 -0500 |
| |
Hi Sekhar,
On 05/22/2018 04:38 AM, Sekhar Nori wrote: > Hi David, > > On Friday 18 May 2018 10:18 PM, David Lechner wrote: >> This series converts mach-davinci to use the common clock framework. >> >> The series works like this, the first 3 patches fix some issues with the clock >> drivers that have already been accepted into the mainline kernel. >> >> Then, starting with "ARM: davinci: pass clock as parameter to >> davinci_timer_init()", we get the mach code ready for the switch by adding the >> code needed for the new clock drivers and adding #ifndef CONFIG_COMMON_CLK >> around the legacy clocks so that we can switch easily between the old and the >> new. >> >> "ARM: davinci: switch to common clock framework" actually flips the switch >> to start using the new clock drivers. Then the next 8 patches remove all >> of the old clock code. >> >> The final four patches add device tree clock support to the one SoC that >> supports it. >> >> This series has been tested on TI OMAP-L138 LCDK (both device tree and legacy >> board file). > > If you do end up sending a v12, you can leave out the mach-davinci > portions unless there are any changes you need to make. I will pick them > up from this series once the driver dependencies are merged. > > I do hope the drivers/clk/* changes can be merged from v4.18. > > Thanks, > Sekhar >
Are you going to pick up the arch patches from this series now that the 4.18 merge window is closed?
All of the clk patches landed in 4.18.
| |