lkml.org 
[lkml]   [2018]   [Jun]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v2] ARM: dts: BCM5301X: Make usb3 phy use mdio phy driver
Date
On Mon,  9 Apr 2018 18:31:53 -0400, Vivek Unune <npcomplete13@gmail.com> wrote:
> Currently, usb3 phy in bcm5301x.dtsi uses platform driver which
> requires register range "ccb-mii" <0x18003000 0x1000>. This range
> overlaps with mdio cmd and param registers (<0x18003000 0x8>).
> Essentially, the platform driver partly acts like a mdio bus
> driver, hence to use of this register range.
>
> In some Northstar devices like Linksys EA9500, secondary switch
> is connected via external mdio. The only way to access and
> configure the external switch is via mdio bus. When we enable the
> mdio bus in it's current state, the mdio bus and any child buses
> fail to register because of the register range overlap.
>
> On Northstar, the usb3 phy is connected at address 0x10 on the
> internal mdio bus. This change moves the usb3_phy node and makes
> it a child node of internal mdio bus.
>
> Thanks to Rafał Miłecki's commit af850e14a7ae
> ("phy: bcm-ns-usb3: add MDIO driver using proper bus layer") the
> same usb3 platform driver can now act as usb3 phy mdio driver.
>
> Tested on Linksys Panamera (EA9500)
>
> Signed-off-by: Vivek Unune <npcomplete13@gmail.com>
> ---

Applied to devicetree/next, thanks!
--
Florian

\
 
 \ /
  Last update: 2018-06-12 20:51    [W:0.079 / U:0.188 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site