lkml.org 
[lkml]   [2018]   [May]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
SubjectRe: [PATCH 3/6] firmware: differentiate between signed regulatory.db and other firmware
From
Date
On Tue, 2018-05-08 at 17:34 +0000, Luis R. Rodriguez wrote:
> On Thu, May 03, 2018 at 08:24:26PM -0400, Mimi Zohar wrote:
> > On Fri, 2018-05-04 at 00:07 +0000, Luis R. Rodriguez wrote:
> > > On Tue, May 01, 2018 at 09:48:20AM -0400, Mimi Zohar wrote:
> > > > Allow LSMs and IMA to differentiate between signed regulatory.db and
> > > > other firmware.
> > > >
> > > > Signed-off-by: Mimi Zohar <zohar@linux.vnet.ibm.com>
> > > > Cc: Luis R. Rodriguez <mcgrof@suse.com>
> > > > Cc: David Howells <dhowells@redhat.com>
> > > > Cc: Kees Cook <keescook@chromium.org>
> > > > Cc: Seth Forshee <seth.forshee@canonical.com>
> > > > Cc: Johannes Berg <johannes.berg@intel.com>
> > > > ---
> > > > drivers/base/firmware_loader/main.c | 5 +++++
> > > > include/linux/fs.h | 1 +
> > > > 2 files changed, 6 insertions(+)
> > > >
> > > > diff --git a/drivers/base/firmware_loader/main.c b/drivers/base/firmware_loader/main.c
> > > > index eb34089e4299..d7cdf04a8681 100644
> > > > --- a/drivers/base/firmware_loader/main.c
> > > > +++ b/drivers/base/firmware_loader/main.c
> > > > @@ -318,6 +318,11 @@ fw_get_filesystem_firmware(struct device *device, struct fw_priv *fw_priv)
> > > > break;
> > > > }
> > > >
> > > > +#ifdef CONFIG_CFG80211_REQUIRE_SIGNED_REGDB
> > > > + if ((strcmp(fw_priv->fw_name, "regulatory.db") == 0) ||
> > > > + (strcmp(fw_priv->fw_name, "regulatory.db.p7s") == 0))
> > > > + id = READING_FIRMWARE_REGULATORY_DB;
> > > > +#endif
> > >
> > > Whoa, no way.
> >
> > There are two methods for the kernel to verify firmware signatures.
>
> Yes, but although CONFIG_CFG80211_REQUIRE_SIGNED_REGDB is its own kernel
> mechanism to verify firmware it uses the request_firmware*() API for
> regulatory.db and regulatory.db.p7s, and IMA already can appraise these two
> files since the firmware API is used.

IMA-appraisal can verify a signature stored as an xattr, but not a
detached signature.  That support could be added, but isn't there
today.  Today, a regulatory.db signature would have to be stored as an
xattr. 

>
> As such I see no reason to add a new ID for them at all.
> K
> Its not providing an *alternative*, its providing an *extra* kernel measure.
> If anything CONFIG_CFG80211_REQUIRE_SIGNED_REGDB perhaps should be its own
> stacked LSM. I'd be open to see patches which set that out. May be a
> cleaner interface.
>
> > If both are enabled, do we require both signatures or is one enough.
>
> Good question. Considering it as a stacked LSM (although not implemented
> as one), I'd say its up to who enabled the Kconfig entries. If IMA and
> CONFIG_CFG80211_REQUIRE_SIGNED_REGDB are enabled then both. If someone enabled
> IMA though, then surely I agree that enabling
> CONFIG_CFG80211_REQUIRE_SIGNED_REGDB is stupid and redundant, but its up to the
> system integrator to decide.

Just because IMA-appraisal is enabled in the kernel doesn't mean that
firmware signatures will be verified.  That is a run time policy
decision.

>
> If we however want to make it clear that such things as
> CONFIG_CFG80211_REQUIRE_SIGNED_REGDB are not required when IMA is enabled we
> could just make the kconfig depend on !IMA or something? Or perhaps a new
> kconfig for IMA which if selected it means that drivers can opt to open code
> *further* kernel signature verification, even though IMA already is sufficient.
> Perhaps CONFIG_ENABLE_IMA_OVERLAPPING, and the driver depends on it?

The existing CONFIG_IMA_APPRAISE is not enough.  If there was a build
time IMA config that translated into an IMA policy requiring firmware
signature verification (eg. CONFIG_IMA_APPRAISE_FIRMWARE), this could
be sorted out at build time.

> > Assigning a different id for regdb signed firmware allows LSMs and IMA
> > to handle regdb files differently.
>
> That's not the main concern here, its the precedent we are setting here for
> any new kernel interface which open codes firmware signing on its own. What
> you are doing means other kernel users who open codes their own firmware
> signing may need to add yet-another reading ID. That doesn't either look
> well on code, and seems kind of silly from a coding perspective given
> the above, in which I clarify IMA still is doing its own appraisal on it.

Suppose,

1. Either CONFIG_CFG80211_REQUIRE_SIGNED_REGDB or
"CONFIG_IMA_APPRAISE_FIRMWARE" would be configured at build.

2. If CONFIG_CFG80211_REQUIRE_SIGNED_REGDB is configured, not
"CONFIG_IMA_APPRAISE_FIRMWARE", a custom IMA-policy rule that
appraises the firmware signature could be defined.  In this case, both
signature verification methods would be enforced.

then READING_FIRMWARE_REGULATORY_DB would not be needed.

Mimi

>
> > > > fw_priv->size = 0;
> > > > rc = kernel_read_file_from_path(path, &fw_priv->data, &size,
> > > > msize, id);
> > > > diff --git a/include/linux/fs.h b/include/linux/fs.h
> > > > index dc16a73c3d38..d1153c2884b9 100644
> > > > --- a/include/linux/fs.h
> > > > +++ b/include/linux/fs.h
> > > > @@ -2811,6 +2811,7 @@ extern int do_pipe_flags(int *, int);
> > > > id(FIRMWARE, firmware) \
> > > > id(FIRMWARE_PREALLOC_BUFFER, firmware) \
> > > > id(FIRMWARE_FALLBACK, firmware) \
> > > > + id(FIRMWARE_REGULATORY_DB, firmware) \
> > >
> > > Why could IMA not appriase these files? They are part of the standard path.
> >
> > The subsequent patch attempts to verify the IMA-appraisal signature, but on
> > failure it falls back to allowing regdb signatures.
> > For systems that only want to load firmware based on IMA-appraisal, then
> >regdb wouldn't be enabled.
>
> I think we can codify this a bit better, without a new ID.
>
> Luis
>

\
 
 \ /
  Last update: 2018-05-09 13:31    [W:0.105 / U:0.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site