lkml.org 
[lkml]   [2018]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 2/3] usb: dwc3: Add Qualcomm DWC3 glue driver
From
Date


On 5/5/2018 12:18 AM, Manu Gautam wrote:
> DWC3 controller on Qualcomm SOCs has a Qscratch wrapper.
> Some of its uses are described below resulting in need to
> have a separate glue driver instead of using dwc3-of-simple:
> - It exposes register interface to override vbus-override
> and lane0-pwr-present signals going to hardware. These
> must be updated in peripheral mode for DWC3 if vbus lines
> are not connected to hardware block. Otherwise RX termination
> in SS mode or DP pull-up is not applied by device controller.
> - pwr_events_irq_stat support to check if USB2 PHY is in L2 state
> before glue driver proceeds with suspend.
> - Support for wakeup interrupts lines that are asserted whenever
> there is any wakeup event on USB3 or USB2 bus.
> - Support to replace pip3 clock going to DWC3 with utmi clock
> for hardware configuration where SSPHY is not used with DWC3.
>
> Signed-off-by: Manu Gautam <mgautam@codeaurora.org>
[snip]
> +static const struct of_device_id dwc3_qcom_of_match[] = {
> + { .compatible = "qcom,dwc3" },

I should also add SOC specific compatibles.
Will do that in next patch.


--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

\
 
 \ /
  Last update: 2018-05-08 06:08    [W:0.749 / U:0.000 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site