lkml.org 
[lkml]   [2018]   [May]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 2/6] PCI: iproc: Add INTx support with better modeling
From
Date
Hi Andy,

On 5/29/2018 5:59 PM, Andy Shevchenko wrote:
> On Wed, May 30, 2018 at 12:58 AM, Ray Jui <ray.jui@broadcom.com> wrote:
>> Add PCIe legacy interrupt INTx support to the iProc PCIe driver by
>> modeling it with its own IRQ domain. All 4 interrupts INTA, INTB, INTC,
>> INTD share the same interrupt line connected to the GIC in the system,
>> while the status of each INTx can be obtained through the INTX CSR
>> register
>
>> + while ((status = iproc_pcie_read_reg(pcie, IPROC_PCIE_INTX_CSR) &
>> + SYS_RC_INTX_MASK) != 0) {
>> + for_each_set_bit(bit, &status, PCI_NUM_INTX) {
>> + virq = irq_find_mapping(pcie->irq_domain, bit + 1);
>> + if (virq)
>> + generic_handle_irq(virq);
>> + else
>> + dev_err(dev, "unexpected INTx%u\n", bit);
>> + }
>> + }
>
> do {
> status = ...;
> for_each_set_bit() {
> ...
> }
> } while (status);
>
> would look slightly better for my opinion.
>

Indeed. I agree with you. I'll wait for comments before sending out v2
which will include this improvement.

Thanks,

Ray

\
 
 \ /
  Last update: 2018-05-30 19:27    [W:0.059 / U:35.656 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site