lkml.org 
[lkml]   [2018]   [May]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] mtd: nand: raw: atmel: add module param to avoid using dma
From
Date


On 29.05.2018 18:15, Boris Brezillon wrote:
> On Tue, 29 May 2018 18:01:40 +0300
> Eugen Hristev <eugen.hristev@microchip.com> wrote:
>
>> [...]
>>
>>
>>>
>>> I think you're missing something here. We use the DMA engine in memcpy
>>> mode (SRAM -> DRAM), not in device mode (dev -> DRAM or DRAM -> dev).
>>> So there's no dmas prop defined in the DT and there should not be.
>>>
>>> Regards,
>>>
>>> Boris
>>>
>>
>> Ok, so the memcpy SRAM <-> DRAM will hog the transfer between DRAM and
>> LCD if my understanding is correct. That's the DMA that Peter wants to
>> disable with his patch ?
>>
>> Then we can then try to force NFC SRAM DMA channels to use just DDR port
>> 1 or 2 for memcpy ?
>
> You mean the dmaengine? According to "14.1.3 Master to Slave Access"
> that's already the case.
>
> Only DMAC0 can access the NFC SRAM and it's done through DMAC0:IF0,
> then access to DDR is going through port DDR port 1 (DMAC0:IF1) or 2
> (DMAC0:IF0).

If we can make NFC use port 1 only, then HLCDC could have two ports as
master 8 & 9, maybe a better bandwidth.

>
>>
>> I have also received a suggestion to try to increase the porches in
>> LCDC_LCDCFG3 .
>
> Yep, Nicolas suggested something similar. Peter, can you try that?
>

\
 
 \ /
  Last update: 2018-05-29 17:24    [W:0.056 / U:0.856 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site