[lkml]   [2018]   [May]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v11 00/27] ARM: davinci: convert to common clo ck framework​
On 05/22/2018 04:38 AM, Sekhar Nori wrote:
> Hi David,
> On Friday 18 May 2018 10:18 PM, David Lechner wrote:
>> This series converts mach-davinci to use the common clock framework.
>> The series works like this, the first 3 patches fix some issues with the clock
>> drivers that have already been accepted into the mainline kernel.
>> Then, starting with "ARM: davinci: pass clock as parameter to
>> davinci_timer_init()", we get the mach code ready for the switch by adding the
>> code needed for the new clock drivers and adding #ifndef CONFIG_COMMON_CLK
>> around the legacy clocks so that we can switch easily between the old and the
>> new.
>> "ARM: davinci: switch to common clock framework" actually flips the switch
>> to start using the new clock drivers. Then the next 8 patches remove all
>> of the old clock code.
>> The final four patches add device tree clock support to the one SoC that
>> supports it.
>> This series has been tested on TI OMAP-L138 LCDK (both device tree and legacy
>> board file).
> If you do end up sending a v12, you can leave out the mach-davinci
> portions unless there are any changes you need to make. I will pick them
> up from this series once the driver dependencies are merged.
> I do hope the drivers/clk/* changes can be merged from v4.18.

I have resent all of the clk patches (including all of the ones I listed as
dependencies in addition to the three remaining in this series) under the
cover "clk: davinci: outstanding fixes​".

I also found that we need to add power-domains properties to the PWM nodes
in "ARM: dts: da850: Add clocks". I probably should just take your advice
and just globally added them even if they are not documented for some types

 \ /
  Last update: 2018-05-25 20:22    [W:0.096 / U:45.732 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site