lkml.org 
[lkml]   [2018]   [May]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 0/4] ARM: dts: am437x boards: Correct (again) tps65218 irq type
* Keerthy <j-keerthy@ti.com> [180509 04:03]:
>
>
> On Tuesday 08 May 2018 07:46 PM, Tony Lindgren wrote:
> > * Peter Ujfalusi <peter.ujfalusi@ti.com> [180508 13:22]:
> >> Hi,
> >>
> >> While based on the datasheet of tps65218 the INT is low active, the GIC_SPI
> >> does not support anythin but IRQ_TYPE_LEVEL_HIGH or IRQ_TYPE_EDGE_RISING:
> >>
> >> [ 2.761814] genirq: Setting trigger mode 8 for irq 102 failed (irq_chip_set_type_parent+0x0/0x30)
> >> [ 2.770913] tps65218 0-0024: Failed to request IRQ 102 for tps65218: -22
> >> [ 2.777854] tps65218: probe of 0-0024 failed with error -22
> >
> > So does the tps65218 have some register to control the interrupt
> > direction or is it's datasheet wrong?
> >
> > BTW, ADC might be a good test case for PMIC interrupt if it has one.
>
> There is no ADC on this PMIC.
>
> >
> >> Use LEVEL_HIGH for the interrupt as it looks to be the correct setting:
> >> INTn of tps65218 is connected to NMIn of the SoC.
> >>
> >> The offending patches are only in linux-next.
> >
> > OK

Applying these all into omap-for-v4.18/dt.

Regards,

Tony

\
 
 \ /
  Last update: 2018-05-15 20:16    [W:0.093 / U:0.148 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site