lkml.org 
[lkml]   [2018]   [May]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v1 3/5] arm64: dts: rockchip: Add gpio-syscon10 to rk3328
From
Date
On 2018-05-11 8:24 PM, Rob Herring wrote:
> On Thu, May 10, 2018 at 10:45 PM, Levin Du <djw@t-chip.com.cn> wrote:
>> On 2018-05-10 8:50 PM, Robin Murphy wrote:
>>> On 10/05/18 10:16, djw@t-chip.com.cn wrote:
>>>> From: Levin Du <djw@t-chip.com.cn>
>>>>
>>>> Adding a new gpio controller named "gpio-syscon10" to rk3328, providing
>>>> access to the pins defined in the syscon GRF_SOC_CON10.
>>>
>>> This is the GPIO_MUTE pin, right? The public TRM is rather vague, but
>>> cross-referencing against the datasheet and schematics implies that it's the
>>> "gpiomut_*" part of the GRF bit names which is most significant.
>>>
>>> It might be worth using a more descriptive name here, since "syscon10" is
>>> pretty much meaningless at the board level.
>>>
>>> Robin.
>>>
>> Previously I though other bits might be able to reference from syscon10,
>> other than GPIO_MUTE alone.
>> If it is renamed to gpio-mute, then the GPIO_MUTE pin is accessed as
>> `<&gpio-mute 1>`. Yet other
>> bits in syscon10 can also be referenced, say, `<&gpio-mute 10>`, which is
>> not good.
>>
>> I'd like to add a `gpio,syscon-bit` property to gpio-syscon, which overrides
>> the properties
>> of bit_count, data_bit_offset and dir_bit_offset in the driver. For
> No. Once you are describing individual register bits, it is too low
> level for DT.

Okay. So I'll rename it to gpio_mute, and reference the output pin as
<&gpio_mute 1>:

+ // Use <&gpio_mute 1> to ref to GPIO_MUTE pin
+ gpio_mute: gpio-mute {
+ compatible = "rockchip,gpio-syscon";
+ gpio-controller;
+ #gpio-cells = <2>;
+ gpio,syscon-dev = <0 0x0428 0>;
+ };
};


Thanks
Levin


\
 
 \ /
  Last update: 2018-05-14 03:29    [W:0.195 / U:0.124 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site