lkml.org 
[lkml]   [2018]   [Apr]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] ARM: dts: BCM5301X: Make usb3 phy use mdio phy driver
From
Date
On 04/09/2018 03:31 PM, Vivek Unune wrote:
> Currently, usb3 phy in bcm5301x.dtsi uses platform driver which
> requires register range "ccb-mii" <0x18003000 0x1000>. This range
> overlaps with mdio cmd and param registers (<0x18003000 0x8>).
> Essentially, the platform driver partly acts like a mdio bus
> driver, hence to use of this register range.
>
> In some Northstar devices like Linksys EA9500, secondary switch
> is connected via external mdio. The only way to access and
> configure the external switch is via mdio bus. When we enable the
> mdio bus in it's current state, the mdio bus and any child buses
> fail to register because of the register range overlap.
>
> On Northstar, the usb3 phy is connected at address 0x10 on the
> internal mdio bus. This change moves the usb3_phy node and makes
> it a child node of internal mdio bus.
>
> Thanks to Rafał Miłecki's commit af850e14a7ae
> ("phy: bcm-ns-usb3: add MDIO driver using proper bus layer") the
> same usb3 platform driver can now act as usb3 phy mdio driver.
>
> Tested on Linksys Panamera (EA9500)
>
> Signed-off-by: Vivek Unune <npcomplete13@gmail.com>
> ---
> v2: Disabled usb3_phy by default, then enabled in dts where
> necessary

Rafal, Hauke, this looks good to me, can you review? Thanks
--
Florian

\
 
 \ /
  Last update: 2018-04-19 00:32    [W:0.091 / U:0.548 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site